User manual SONY ICF-CD7000

[. . . ] To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus. connect the apparatus to an easily accessible AC outlet. [. . . ] Remove the old battery and install a new one. the CD , radio or buzzer alarm does not sound at the preset alarm time. Hasn't "ALARM A" or "ALARM B" in the display gone out?The disc should be inserted with the label side up. dusty or defective disc -- Clean the disc with an optional cleaning cloth. Take out the CD and leave the CD compartment open for about an hour to allow condensation to evaporate. This unit is preset to the current date and time at the factory, and is powered by the back up battery. All you need to do the first time is just plug it in, select your time zone. The area number appears in the display for a few seconds and then the display returns to the current time. After the current time reappears, press TIMEZONE to check the area number. Note Though the clock is correctly set at the factory, discrepancies may arise during transport or storage. If necessary, set the clock to the correct time by referring to "Setting the Clock Manually". 6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on an optical pick-up block with a 7-mm aperture. " " is displayed from the beginning of daylight saving time (summer time) and disappears at the end of the daylight saving time (summer time) automatically. To preset another station, repeat these steps. To change the preset station, tune in the desired station and hold down the desired PRESET TUNING (1 to 5) until two short beeps sound. After the preset number flashes, "WAKE UP STATION" appears in the display. After about 4 seconds, the display returns to the current time. Note Holding down the desired PRESET TUNING button for 2 seconds or more in step 3 will replace the station previously set to the PRESET TUNING button with the station you are tuned in to. You can directly select the desired wake-up station by pressing RADIO ONBAND or the PRESET TUNING button while the "­ ­" indication is not displayed. A short beep sounds and "WAKE UP VOLUME" appears in the display. "ST" will appear in the display when an FM broadcast is clearly received. [. . . ] replace the battery if "" appears. If a power interruption occurs while the buzzer alarm is sounding, the SNOOZE button will not operate. Press CD CD again ** ** Hold down ** Hold down ** repeatedly** When using a FM1 or FM2 preset mode, you may listen to the radio in either mode (see "Presetting Your Favorite Station"). Pause Resume play after pause Cue to the beginning of the current track (AMS*) Cue to the next track (AMS*) Go back at high speed Go forward at high speed Locate a succeeding track (AMS*) Stop play This CD clock radio is equipped with 3 alarm modes--CD, radio and buzzer. [. . . ]