User manual SONY ICF-CD73

[. . . ] You can set the clock also during the radio reception/CD playback mode. ⷠTo set the current time quickly, rotate and hold in either +/­ direction the TUNE/TIME SET/ TIMER SET dial. ⷠTo set the current time exactly, follow step 2 and press CLOCK again with the time signal of a radio station. Then the current time indication will return to the display. [. . . ] The display shows the frequency for a few seconds and then changes back to the current time. To preset another station, repeat these steps. Make sure the unit is turned off before using house current. Connect the Sony AC power adaptor (supplied*) to the DC IN 6 V jack firmly, and plug it into a wall outlet. When the AC power adaptor is not connected to the DC IN 6 V jack, be sure to close the cover of the DC IN 6 V jack. * Supplied with European model only After a few seconds, the display returns to the current time but the PRESET TUNING button number remains. Note To change the preset station, preset a new station to the button of your choice. For AC operation, use only the recommended AC power adaptor. ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to a wall outlet, even if the unit itself has been turned off. In vehicles or buildings, radio reception may be difficult or subject to interference. ⷠSince a strong magnet is used for the speaker, keep away personal credit cards using magnetic coding or spring-wound watches from the unit to prevent possible damage from the magnet. ⷠTo clean the casing, use a soft cloth dampened with water, wipe it again with a dry cloth. Do not use soap or detergent; do not dry with an electric hair dryer. Note on condensation If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. notes on CDs · Before playing, clean the CD with a cleaning cloth. Using the AC power adaptor ⷠWhen operating the unit with an external power source, do not remove the batteries. These batteries serve to backup the clock and memory settings. Since the batteries discharge in this case as well, we recommend changing them about once a year. ⷠTo prevent battery leakage, we recommend removing the batteries when the unit is connected to a wall outlet. ⷠBefore connecting and disconnecting the external power source plug, be sure to turn off the radio/CD. [. . . ] The strap is only for hanging the unit, do not use the strap to carry it. ⷠDo not hang the unit from where it easily fall down. The channel step of this unit is factory-set to 9 kHz or 10 kHz to change the setting as shown below to be able to listen to the radio. Area North America/Mexico Other countries/regions Channel step 10 kHz 9 kHz The beep alarm will go off when the count down time has elapsed. [. . . ]