User manual SONY ICF-CD837

[. . . ] · Take out the CD and leave the CD compartment open for about an hour to remove moisture condensation. · Dusty or defective disc -- Clean or replace the disc. · Volume too high -- Reduce the volume. · Strong vibration. IMPORTANT SAFEGUARDS INSTALLATION Water and Moisture For your protection, please read these safety instructions completely before operating the appliance, and keep this manual for future reference. [. . . ] 246 × 96 × 210 mm (w/h/d) (Approx. 9 3/4 × 3 7/8 × 8 3/8 inches) incl. projecting parts and controls Mass: Approx. 1 750 g (3 lb 86 oz) Design and specifications are subject to change without notice. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. Features · Built-in CD player with CD-R/RW playback function · Easy to see large green LED display with variable brightness control function · Wake to any track of a CD, Radio or Buzzer (dual alarm) · Easy nap timer -one push operation · Extendable snooze time from 10 to 60 minutes · Various CD play modes with Shuffle/Repeat function ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lead-free solder is used for soldering. Halogenated flame retardants are not used in printed wiring boards. Precautions · Operate the unit on the power source specified in the "Specifications. " · The nameplate indicating operating voltage, etc. · To disconnect the power cord (mains lead), pull it out by the plug, not the cord. · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. · Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. · To clean the casing, use a soft cloth dampened with a mild detergent solution. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Antenna Grounding According to the National Electrical Code Antenna Lead-in Wire Ground Clamps Electric Service Equipment NEC-NATIONAL ELECTRICAL CODE Antenna Discharge Unit (NEC Section 810-20) Grounding Conductors (NEC Section 810-20) Ground Clamps Power Service Grounding Electrode System (NEC Art 250 Part H) SERVICE Damage Requiring Service Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions: -When the power cord or plug is damage or frayed. -If liquid has been spilled or objects have fallen into the appliance. -If the appliance has been exposed to rain or water. [. . . ] ALARM A or ALARM B indicator go off. * AMS = Automatic Music Sensor **These operations are possible during both play and pause. · During CD playback, every time you press CLOCK SET/TRACK, the current time and the track number appear in the display alternately. To Set the Alarm Time 1 If you will select the CD alarm or radio alarm, adjust the volume. Also, if you will select the radio alarm, tune in to the desired station. Set the ALARM MODE selector to CD, RADIO or BUZZER. [. . . ]