User manual SONY ICF-CD853V

[. . . ] 3-238-440-21(1) WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Precautions · Operate the unit on the power source specified in the "Specifications. " · The nameplate indicating operating voltage, etc. · To disconnect the power cord (mains lead), pull it out by the plug, not the cord. · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. [. . . ] Never spill liquid of any kind on the appliance. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 4­ohm loads, both channels driven from 100 ­ 10 000 Hz; rated 1. 0 W per channelminimum RMS power, with no more than 10 % total harmonic distortion in AC operation. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. CD player section System: Compact disc digital audio system Laser diode properties: Material: GaAlAs Wavelength: 780 nm Emission duration: Continuous Laser output: Less than 44. 6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture. ) +1 Frequency response: 20-20 000 Hz ­1. 5 dB Wow and flutter: Below measurable limit Antenna Grounding According to the National Electrical Code Antenna Lead-in Wire Ground Clamps Electric Service Equipment NEC-NATIONAL ELECTRICAL CODE Antenna Discharge Unit (NEC Section 810-20) Grounding Conductors (NEC Section 810-20) Ground Clamps Power Service Grounding Electrode System (NEC Art 250 Part H) TY RAN WAR dio) TED u LIMI rtable A (Po CAUTION The use of optical instruments with this product will increase eye hazard. Radio section Frequency range: TV: 2 ­ 13 ch WEATHER: 1 ­ 7 ch FM: 87. 5 ­ 108 MHz AM: 530 ­ 1 710 kHz Before You Begin Thank you for choosing the Sony CD clock radio!It will give you many hours of reliable service and listening pleasure. Before operating the unit, please read these instructions thoroughly and retain them for future reference. General Time display: 12-hour system Speaker: 66 mm (2 5/8 inches) dia. , 4 Outputs: i (headphones) jack (ø 3. 5 mm stereo minijack) Power outputs: 1. 2W + 1. 2W (at 10% harmonic distortion) Power requirements: 120 V AC, 60 Hz Dimensions: Approx. 185. 5 × 176 × 210. 5 mm (w/h/d) (Approx. 7 3/8 × 7 × 8 3/8 inches) incl. projecting parts and controls Mass: Approx. To handle compact discs Correct Handle the disc by its edge. Presetting Your Favorite Station --Preset Tuning You can preset up to 10 stations in FM (5 stations in FM1, 5 stations in FM2), and 5 stations in each AM, TV, WEATHER. 5 Repeat step 3 to set the minute and press ALARM SET RADIO. "WAKE UP STA" appears and the preset number flashes on the display. ALARM OFF-- The CD, radio, or buzzer alarm is turned off automatically after 60 minutes. 6 Press TUNE/TIME SET + or ­ to select the wake-up station. Preset number changes in the order as follows: PAM P1 to 5 TV P1 to 5 FM1 P1 to 5 FM2 P1 to 5 To Stop the Alarm Press OFF x·ALARM RESET to turn off the alarm. The alarm will come on again at the same time the next day. Presetting a Station 1 Follow steps 1 to 4 in "Playing the 2 Radio" and manually tune in to the station you wish to preset. Hold down the PRESET TUNING button you wish to preset until you hear two short beeps. Example: Display window when you preset FM 90 MHz in the PRESET TUNING 2 button for FM2. The frequency remains on the display for about 10 seconds and then returns to the previous display. To preset another station, repeat these steps. To change the preset station, tune in to the desired station and hold down the PRESET TUNING 1 to 5 button. The new station will replace the previous station on the PRESET TUNING button. WEATHER P1 to 5 To Deactive the Alarm Press ALARM MODE repeatedly until CD/ RADIO/BUZZER indicator go off. Incorrect The PRESET TUNING 3 button has a tactile dot. FM wire antenna There is a tactile dot beside volume to show the direction to turn up the volume. Do not touch the surface. "P­" is the last received station. You can directly select the desired wake-up station by pressing RADIO·BAND or the PRESET TUNING button while the indication "P­" is not displayed. 7 Using the NAP Timer (Count Down Timer) The NAP timer sounds the buzzer after a preset time duration. [. . . ] When headphones (not supplied) are plugged into the unit, buzzer alarm through the speakers and the headphones regardless of the alarm mode setting. In this case, the unit will not play a CD or radio. Note When CD, radio and buzzer alarms are set for the same time, the CD alarm takes precedence. If the CD alarm is not set, the radio alarm takes precedence. 3 When using FM1 or FM2 preset mode, you may listen to the radio on either mode (See "Presetting Your Favorite Station"). Use TUNE/TIME SET + or ­ to tune in to a station. Two short beeps sound when the minimum frequency of each band is received during tuning. 4 5 Press ALARM SET CD. The minute will flash. Repeat step 3 to set the minute and press ALARM SET CD. The wake-up track number flashes on the display. To listen with a headphones (not supplied) Connect an headphones (not supplied) to the i jack. [. . . ]