User manual SONY ICF-CD855V

[. . . ] 3-262-864-21(1) WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. 2004 Sony Corporation Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. Printed in China Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Cleaning Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 8­ohm loads, both channels driven from 100 ­ 10 000 Hz; rated 1. 0 W per channel-minimum RMS power, with no more than 10% total harmonic distortion in AC operation. Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Unauthorized substitutions may result in fire, electric shock, or other hazards. Safety Check Upon completion of any service or repairs to the appliance, ask the service technician to perform routine safety checks (as specified by Sony) to determine that the appliance is in safe operating condition. To Pause Resume play after pause Press CD u CD u again . ** >** Hold down . ** Hold down >** . repeatedly** > repeatedly** x Playing the Radio --Manual Tuning 1 Press RADIO ON·BAND to turn on the radio. "RADIO" appears on the display. 2 3 Press RADIO ON·BAND repeatedly to select FM 1 or FM 2. Press MODE. "FM MONO" appears in the display. To revert to stereo mode, press MODE again. C Setting the Buzzer Alarm 1 Perform steps 1 to 5 in "To set the Alarm Time. " RADIO FM MONO SLEEP ALARM A AM PM WEATHER FM1FM2 TVAM PM VOL NAP WAKE UP TRACK CD SHUFFLE REP 1 ALL Locate the beginning of the current track (AMS*) Locate the next track (AMS*) Go back at high speed Go forward at high speed Locate the previous track (AMS*) 2 Press ALARM A or B to select "BUZZER" alarm mode. Two short beeps will confirm the setting. If the BUZZER indicator does not light, press ALARM A or B to light the BUZZER indicator, and the buzzer will sound at the set time. ALARM B MHz AM kHz PM 2 Press RADIO ON·BAND repeatedly to select the desired band. Each press changes the band as follows: Setting the Alarm This clock radio is equipped with 3 alarm modes-- CD, radio and buzzer. Before setting the alarm, make sure to set the clock (see "Setting the Clock"). AM FM1 FM2 TV The PRESET TUNING 3 button has a tactile dot. BRIGHTNESS CLOCK Locate the succeeding track (AMS*) Stop play CD RADIO WEATHER CD HI RADIO BUZZER ALARM A MID * AMS = Automatic Music Sensor ** These operations are possible during both play and pause. When using FM1 or FM2 preset mode, you may listen to the radio on either mode (See "Presetting Your Favorite Station"). To Set the Alarm Time 1 Press ALARM A or B for a few seconds. After one beep, "ALARM" and the hour will flash on the display. ALARM ON-- Press ALARM A or B to activate the alarm setting. If the setting indicator does not light, the alarm setting is not activated. You can only check the alarm setting when it is activated. If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound in its place at the time set. For the alarm, the beeping of the alarm becomes more rapid after every few seconds in three progressive stages. [. . . ] The new station will replace the previous station on the PRESET TUNING button. Perform steps 1 to 5 in "To set the Alarm Time. " Press ALARM A or B to select "RADIO" alarm mode. "WAKE UP STATION" appears and the preset number flashes on the display. All the tracks are played once. m "REP 1" (single repeat) A single track is played repeatedly. m 3 Press TUNE·TIME SET + or ­ to select the desired wake-up station. Preset number changes in the order as follows: To Stop the NAP Timer Press NAP or OFF x·ALARM RESET to turn off the buzzer. "REP ALL" Push (all repeat) To set the current time rapidly, hold down TUNE·TIME SET + or ­. In step 4, when you press CLOCK after the minute setting to activate the clock, the seconds start counting from zero. [. . . ]