User manual SONY ICF-CD863

[. . . ] Area North and South American countries Other countries Channel step 10 kHz 9 kHz You can directly select the desired wake-up station by pressing RADIO/BAND or the PRESET TUNING button while the indication "P­" is not displayed. When the sleep timer reaches a remaining time of a few minutes, "SLEEP" will flash in the display and the sound output will gradually decrease in volume (Gentle Sleep function). If you press VOL + or ­ at this time, "SLEEP" will light up and the decrease in the volume will stop. To turn off the CD or the radio before the preset time, press SNOOZE· Two short beeps sound when the minimum frequency of each band is received during tuning. [. . . ] if the problem persists , consult the nearest Sony dealer. The clock does not show the correct time. ⷠHas an electrical power outage lasting more than one minute occurred?Hasn't all ALARM indicator lights gone out?The disc should be placed with the labelled side up. ⷠTake out the CD and leave the CD compartment open for about an hour to get rid of moisture condensation. The auto brightness sensor may be covered or shadowed by something. Pause Resume play after pause Locate the beginning of the current track (AMS*) The frequency remains on the display for about 10 seconds and then returns to the previous display. To preset another station, repeat these steps. If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound in its place at the time set. For the buzzer alarm, the beeping of the alarm becomes more rapid and sounds increasing in volume (Gentle Wake function) after every few seconds in three progressive stages. When headphones (not supplied) are plugged into the unit, buzzer alarm through the speakers and the headphones regardless of the alarm mode setting. In this case, the unit will not play a CD or radio. Note When CD, radio and buzzer alarms are set for the same time, the CD alarm takes precedence. If the CD alarm is not set, the radio alarm takes precedence. Locate the next track (AMS) Go forward at high speed Locate the previous track (AMS) Go back at high speed Hold down . After about 10 seconds, the display will return to the previous display but the PRESET TUNING button number will remain. Note Holding down the desired PRESET TUNING button for more than a few seconds in step 3 will replace the previous station on the PRESET TUNING button with the station you tuned in to. Locate the succeeding > repeatedly** track (AMS) Stop play x * AMS = Automatic Music Sensor **These operations are possible during both play and pause. About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs but playback capability may vary depending on the quality of the disc, the recording device and application software. The CD, radio or buzzer alarm turns off but will be automatically activated again after about 10 minutes. Every time you press SNOOZE· 6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture. [. . . ] M "REP 1" (single repeat) A single track is played repeatedly. m "REP ALL" (all repeat) All the tracks are played repeatedly. M "SHUFFLE" (shuffle play) All the tracks are played once in random order. The NAP indicator turns on, " " and the NAP time is displayed for a few seconds. [. . . ]