User manual SONY ICF-F12S

[. . . ] ⷠAllow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, blanket, etc. ) or near materials (a curtain) that might block the ventilation holes. ⷠShould any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. [. . . ] For the sound alarm, the sound you specified as the wake-up sound is played. Each press changes the band as follows: ICF-F12S AM Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. When using FM1 or FM2 preset mode, you may listen to the radio on either mode. Time display UK, Australia, North and South America Other countries/regions 12 hour 24 hour Use TUNING + or ­ to tune into the desired station. " Two short beeps sound when the minimum frequency of each band is received during tuning. To Use the Radio and Buzzer Alarm 1 Set both alarm times for ALARM A or B. Model for other countries/regions Band FM LW ICF-F12S 87. The speaker is deactivated when an earphone is connected (ICF-F12S for European model only) · to check the station being received , press TUNING + or ­ or ON/BAND lightly. The display shows the band and frequency for a few seconds and then changes back to the current time. If the same alarm time is set for both Alarm A and B, Alarm A takes priority. The radio or buzzer turns off but will automatically come on again after about 10 minutes. connect the apparatus to an easily accessible AC outlet. Should you notice an abnormality in the apparatus, disconnect the main plug from the AC outlet immediately. You will hear a beep and the year will start to flash in the display. Press Jog lever v (up) or V (down) until the correct year appears in the display. Repeat steps 3 and 4 to set the month, day, hour, and minute. After setting the minute, press ENTER/ BRIGHTNESS to start the counting of the seconds, and you will hear two short beeps. Tuning into a preset station 1 Press ON/BAND to turn on the radio. You can fall asleep to the radio using the built-in sleep timer that turns off the radio automatically after a preset duration. You can set the sleep timer to durations of 90, 60, 30, or 15 minutes. Every push changes the display as follows: In step 5, when you press ENTER/BRIGHTNESS after the minute setting to activate the clock, the seconds start counting from zero. ⷠWhen the alarm setting mode is entered, the clock cannot be set. [. . . ] Radio reception is interrupted while the alarm time is being set. Press SNOOZE/DATE/SLEEP OFF once for the date, and within 2 seconds press it again for the year. The display shows the date or year for a few seconds and then changes back to the current time. Green backlight LCD with adjustable brightness. [. . . ]