User manual SONY ICF-M410S

[. . . ] â· To extend the time until the radio turns off, press SLEEP again to set the time. It will give you many hours of reliable service and listening pleasure. Before operating the radio, please read these instructions thoroughly and retain them for future reference. These instructions cover these models: ICF-M410L and ICF-M410S. [. . . ] Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The front panel buttons do not operate at all. The unit is being used in extremely high or low temperatures or in a place with excessive moisture. Very weak or interrupted sound, or unsatisfactory reception. In a vehicle or in a building, listen near a window. When the batteries become weak, the sound becomes weak and distorted. When the batteries are completely exhausted, "E" appears on the display and the power is turned off. When "E" appears, replace all the batteries with new ones. A station cannot be received when a preset tuning button is pressed. Sound is not heard and " E " appears in the display. Note on replacing the batteries Do not take more than 40 seconds to replace the batteries, otherwise the clock, standby settings and preset stations will be deleted from the memory. Should that happen, reset the functions again. After the batteries are replaced, press POWER to turn the indication off. â· Do not carry the dry batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object. â· When you are not going to use the unit for a long time, remove the batteries to avoid damage from battery leakage and corrosion. â· Do not use different types of batteries at the same time. â· When you replace the batteries, replace all with new ones. Press the desired preset button for more than a few seconds (i. You can hear the confirmation beep and preset number "2" appears in the display To preset another station, repeat these steps. [. . . ] The display will flash "0:00" when the batteries are installed or the AC power adaptor is plugged in for the first time. The clock can be adjusted when the radio is off. Holding down STANDBY for more than about a second sets the standby time. By setting the sleep timer, you can fall asleep to the radio sound. [. . . ]