User manual SONY ICF-M770SL

[. . . ] After that, when the batteries are used up, " E " will light and the power of the unit will be turned off. If this happens, replace the batteries with new ones. After the batteries are replaced, press OPERATION to turn off the indication. notes on replacing the batteries · Before replacing the batteries, make sure that the radio is turned off. [. . . ] ⷠShuttle dial with an analog touch for station selection. ⷠA total of 28 stations can be preset, 14 FM stations and 7 stations each for SW, MW and LW. Note Adjust the direction of the antenna by holding the bottom of it. The antenna can be damaged when you move the antenna with excessive force. You can preset up to 14 FM stations (7 stations each for FM1 and FM2) and 7 stations each for SW, MW and LW. " Press the PRESET TUNING button you wish to preset for more than 2 seconds. You will hear two short beeps and the preset number appears in the display. Example: Display window when you preset FM 90. To preset another station, repeat these steps. Adjust the tone to your preference using TONE. Note Holding down the desired PRESET TUNING button for more than 2 seconds will replace the previous station on the PRESET TUNING button with the station you tuned in to. To release the key protection, slide HOLD in the opposite direction of the arrow so that " - " disappears. You can set the radio to turn on at a preset time. The standby timer can be set whether or not the radio is turned on. For adjusting the hour and minute with TUNE/ TIME SET, see "How to Adjust the Time Digits" in "Setting the Clock. Turn TUNE/TIME SET to set the hour for the radio to be turned on, then press STANDBY TIME SET. Turn TUNE/TIME SET to set the minute, then press STANDBY TIME SET. "0:00" will flash in the display when the batteries are installed or the AC power cord is plugged in for the first time. The clock can be adjusted only when the radio is turned off. * FM1 and FM2 are differenciated only for Preset Tuning. for Manual or Scan Tuning of FM stations , select either band. When you select SW (for ICF-M770S or ICF-M770SL only): As the SW frequencies are assigned to the meter bands shown below, you can make a quick search for a desired frequency by specifying the corresponding meter band. [. . . ] You can press SLEEP repeatedly to select the desired sleep timer setting even after the sleep timer has activated. Scan Tuning begins from the previously received frequency and pauses for 3 seconds when a station is received, then the scanning will continue. While holding down mb/CLOCK (CLOCK for ICF-M770L), keep pressing OPERATION for more than 5 seconds until you hear two short beeps. The MW channel step will be changed and "MW 10 kHz" (or "MW 9 kHz") is displayed for 2 seconds. [. . . ]