User manual SONY ICF-SW100S

[. . . ] ­ Scan tuning for rapid automatic search of the desired broadcast station through scanning. Direct tuning for immediate selection of the desired broadcast station when the frequency is known. ­ Preset tuning for instant recall of a preset broadcast station with a single press of the button. The MW channel step of this unit is factoryset to 9 kHz. [. . . ] When receiving MW or LW broadcasts without using the external MW/LW antenna, make sure to disconnect the SW external antenna where applicable. If not, the built-in ferrite bar antenna will not operate and MW/LW broadcast will not be received successfully. For more details on the external antenna, refer to its Operating Instructions manual. For SW reception Use the connection cord supplied with the AN-1 or AN-102 to connect between the OUTPUT jack of the antenna controller and the AM EXT ANT jack of this unit. For MW/LW reception 1 Use the connection cord and antenna coupler supplied with the AN-1 or AN-102 to connect between the OUTPUT jack of the antenna controller and the INPUT jack of the antenna coupler. 2 Position the antenna coupler near the unit where MW/LW reception is optimal. Oe Use the supplied microphone to record a meeting, or simply enjoy recording with the microphone. Use Type I (normal) cassettes only for recording. Insert the cassette with the side you wish to record facing the cassette holder. Before inserting a cassette, make sure that the cassette tab is not broken off. A cassette with a broken tab cannot be recorded. Note When the sleep timer is activated while recording the radio, the recording will stop and the power will turn off. The radio turns off automatically after the selected duration for the operation of the sleep timer elapses. To turn off the radio before the preset duration has elapsed To record the desired broadcast with the timer--Timer recording RADIO The timer recording function enables you to POWER turn on the radio and tune in to your ON/OFF favorite broadcast station at the desired time for recording. Use the timer SLEEP recording function when you wish to record a broadcast while away or STANDBY unattended. Before using the timer ON/OFF recording function, make sure that the clock is set correctly (see page 5). Insert the cassette with the side you wish to record facing the cassette holder. Adjusting VOLUME and TONE does not affect the sound to be recorded. Note Make sure that the radio is turned off before setting the desired standby time. You cannot set the standby time when the radio or cassette is operating. Press HOUR or MIN repeatedly while pressing either a or b of STANDBY MEMORY (which you pressed in step 3) to set the desired standby time for the radio to turn on for recording. Tip To temporarily cancel the standby function, slide HOLD in the direction of the arrow to display "H" while the radio is turned off. [. . . ] The batteries are not inserted into the RADIO BATT battery holder. Oe is pressed while both sides of the cassette is pressing p to display not possible. If you wish to use the tape is broken off to prevent for recording again, cover accidental recording of the opening of the broken your important tape. The timer recording function is not operating when the preset standby time arrives. [. . . ]