User manual SONY ICF-SW7600

[. . . ] To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. Precautions · Operate the unit on the power source specified in the "Specifications. " · To disconnect the power cord (mains lead), pull it out by the plug, not the cord. · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. [. . . ] If the plug should still fail to fit, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized plug by forcing it in. -For the appliance with a three-wire grounding type AC plug: Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 6­ohm loads, both channels driven from 100 ­ 10 000 Hz; rated 1. 4 W per channel-minimum RMS power, with no more than 10 % total harmonic distortion in AC operation. Improving the Reception FM: The AC power cord functions as an FM antenna. Extend the AC power cord fully to improve FM reception. AM: When installing the unit, rotate the unit horizontally for optimum reception and then install the unit. A ferrite bar antenna is built into the unit. This plug will only fit into a grounding-type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Printed on 100% recycled paper using VOC (Volatile Organic Compound)-free vegetable oil based ink. Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. 2004 Sony Corporation Printed in China Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. TV section Television system: American TV standard/NTSC Channel coverage: VHF: 2­13/UHF: 14­69/CATV: 1­125 Antenna: 75-ohm external antenna terminal for VHF/UHF Display type: Wide LCD color monitor Size: 7 inches System: TFT active matrix Number of pixel: 336, 960 pixels Input: 1 video, 1 audio Installing the Unit Under a Cabinet (See Fig. A) The unit can be installed without the spacer. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. The TV will scan through all available channels and program receivable channels. On the remote The TV MENU SET + and - on the main unit is the same as the TUNE/CH + and - on the remote. Notes · Discs with non-standard shapes (e. g. , heart, square, star) cannot be played on this unit. Attempting to do so may damage the unit. · If you press CD u (N on the remote) when there is no disc in the CD compartment, "00" flashes for about 5 seconds on the display and the unit turns off automatically. · After 20 minutes, playback will be stop when you press CD u (X on the remote) during playback. To preset another station, repeat these steps. To change the preset station, tune in to the desired station and hold down the FM/AM PRESET TUNING 1-5 button. The new station will replace the previous station on the FM/AM PRESET TUNING button. Tuning in to a Preset Station 1 Press RADIO ON/BAND to turn on the 2 3 4 radio. Press the desired FM/AM PRESET TUNING button. Adjust the volume using VOLUME(VOL) + or ­. After a few seconds, the display returns to the current time but the PRESET TUNING button number remains. Note Holding down the desired FM/AM PRESET TUNING button for more than a few seconds in step 3 will replace the previous station on the FM/AM PRESET TUNING button with the station you tuned into. On the remote The FM/AM PRESET TUNING 1-5 button on the main unit is the same as the P1-P5 button on the remote. To watch CATV channels You have to subscribe to a cable TV company. [. . . ] After setting the time, the current time is displayed again if you do not perform any operation for more than 65 seconds. C Setting the Clock 1 2 Plug in the kitchen clock radio. The display will flash "AM 12:00". 2 Push TIMER once. Timer indicator lights and beep sounds. While the timer is set, the display shows the remaining time. Press CLOCK for a few seconds. You will hear a beep and the hour will start to flash in the display. PICTURE: Press TV MENU SET + to increase the contrast. Press - to decrease contrast. About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs but playback capability may vary depending on the quality of the disc, the recording device and application software. 4 Select Mono or ST. The mode you select appears in the display for a few seconds and returns to the current time. To display the current time, press CLOCK. Cooking Timer ON-- When the time has elapsed, the buzzer will sound and the TIMER indicator flashes. Even if the CD or the radio, TV is being played, the buzzer of the timer sounds together. [. . . ]