User manual SONY ICF-SW7600GS

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Notice for the customer in the countries applying EU Directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku, Tokyo, Japan. [. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Only insert up to here. 2 A B Features · Dual alarm FM/AM Clock radio with iPod dock. · Various type of alarms- iPod, radio and buzzer. · Automatic time set -- When you plug the clock in for the first time, the current time will be shown in the display. · Automatic Daylight Saving Time/Summer time adjustment. · CLOCK button to display month, day and year. · Brightness control (High/Middle/Low). · No Power No Problem alarm system to keep the clock and the alarm operating during a power interruption with a CR2032 battery installed. 3 4 Make sure the AM loop aerial is connected firmly by pulling softly. Insert the battery compartment back into the unit and secure it with the screw. A-3) Adjusting the AM loop aerial Find a place and an orientation that provide good reception. · Do not place the AM loop aerial near the unit or other AV equipment, as noise may result. In this case, refer to "Setting the clock and date" to set the correct time. · The area number is set to 3 at the factory, but if the unit is reset, the area number is changed to 2. When you use the unit in a Western European time zone, change the area number to 3. And set the time again (see "Setting the clock and date"). * These operations are available only when using the supplied remote commander. Notes · When placing or removing the iPod, keep it straight and parallel with the rear support. · Do not carry the unit with an iPod set on the connector. · When placing or removing the iPod, brace the unit with one hand and take care not to press the controls of the iPod by mistake. · Do not pull on the rear support strongly as it cannot be detached from the unit and may cause a malfunction. · To use an iPod, refer to the user's guide of your iPod. · Before disconnecting the iPod, pause playback. Tip Apple's iPod Universal Dock Adapter can be used with this unit. v To deactivate the alarm Press ALARM SET A (or B) to turn off the ALARM A (or B) indicator from the display. To preset another station, repeat these steps. [. . . ] Repeat steps 2 and 3 to set the month, day and time. After setting the minute the clock starts from 0 seconds. But if you do not set "Minute", the clock does not start from 0 second flat. 2 Press RADIO ON repeatedly to select the desired band. Each press changes the band as follows: Press ALARM SET A for a few seconds. Press TIME SET +/­ to set the desired hour, and press ALARM SET A. Press TIME SET +/­ to set the desired minute, and press ALARM SET A. [. . . ]