User manual SONY ICF-SW77

[. . . ] Do not dismantle or roll up the aerial. Replacing the battery 1 Keep the AC plug connected to the AC outlet, remove the screw that secures the battery holder at the bottom of the unit using a screwdriver, and remove the battery holder (see Fig. ). Replace a new battery in the battery holder with the side facing up (see Fig. ). Insert the battery holder back into the unit and secure it with the screw (see Fig. ). Press (play), RADIO BAND, AUDIO IN or SNOOZE/DATE/SLEEP OFF to turn "" off in the display. Compatible Sony Ericsson Phone models Compatible Sony Ericsson Phone models are as follows. [. . . ] For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. CR2025 Models using the Oval attachment (supplied with your "WALKMAN") NWZ-E440 series: NWZ-E443/E444/E445/ E443K/E444K NWZ-S540 series: NWZ-S544/S545 Notes Do not attempt to charge the battery. If you are not going to use the remote commander for a long time, remove the battery to avoid any damage that may be caused by leakage and corrosion. Specifications Time display 12-hour system "WALKMAN" / Sony Ericsson Phone section "WALKMAN": DC out: 5V MAX: 500mA Sony Ericsson Phone: DC out: 5V MAX: 600mA Radio section Frequency range Band FM AM Frequency 87. 5 MHz ­ 108 MHz 531 kHz ­ 1 602 kHz Channel step 0. 05 MHz 9 kHz About the backup battery To keep accurate time, this unit contains a CR2032 battery as a backup power source. The battery keeps the clock and the alarm operating in the event of a power interruption. Note for customers in the UK The clock is preset at the factory, and its memory is powered by the preinstalled Sony CR2032 battery. If the "AM 12:00" appears in the display when the unit is connected to AC outlet for the first time, the battery may be weak. The preinstalled CR2032 battery is considered part of the product, and is covered by the warranty. You are required to show "Note for customers in the UK" (in this instruction) to a Sony dealer in order to validate the warranty for this product. NWZ-E430 series: NWZ-E435F/E436F/E438F NWZ-S630 series: NWZ-S636F/S638F/S639F/ S636FK NWZ-S730 series: NWZ-S736F/S738F/S739F NWZ-A720 series: NWZ-A726/A728/A729 NW-A800 series: NW-A808/A806/A805 NWZ-A810 series: NWZ-A815/A816/A818 NWZ-A820 series: NWZ-A826/A828/A829/ A826K/A828K/A829K Models using the Type A attachment (supplied with this unit) General Speaker Approx. 8 Input AUDIO IN jack (ø 3. 5 mm stereo minijack) Power output 0. 8 W (at 10% harmonic distortion) Power requirements 230 V AC, 50 Hz For clock back up: 3V DC, CR2032 battery (1) NWZ-S510 series: NWZ-S515/S516 NWZ-S610 series: NWZ-S615F/S616F/S618F NWZ-S710 series: NWZ-S715F/S716F/S718F NWZ-X1000 series: NWZ-X1050/X1060 Models using the Type B attachment (supplied with this unit) Knowing when to replace the battery When the battery becomes weak, "" appears in the display. If a power interruption occurs while the battery is weak, the current time and alarm will be initialized. Replace the battery with a Sony CR2032 lithium battery. 3 Press PRESET + or ­ to select the preset number, then press DISPLAY/MEMORY. The frequency is stored with the selected preset number. * This function may not be available on some models. If the function does not work, press (play) to cancel. Notes The volume may be low when the volume of Sony Ericsson Phone is set to low. In this case, adjust the volume of Sony Ericsson Phone. When removing the Sony Ericsson Phone, hold the Docking Tray securely with one hand and tilt the phone forward. 5 Press ALARM TIME SET + or ­ to select the desired band or "­ ­. " The preset number flashes. to the line out jack or headphone jack of the external equipment using the audio connecting cable (supplied). 6 Press ALARM TIME SET A or B. 7 Press ALARM TIME SET + or ­ to select the desired preset number. The setting is entered. If you select "­ ­, " jump to step 8. Note The Sony Ericsson Phone connector is selected by the default setting. 8 If "A" or "B" does not appear in the The radio will turn on at the set time. Audio connecting cable (supplied) To external equipment To operate a "WALKMAN" 1 Choose the "WALKMAN" attachment 2 that fits your "WALKMAN" (see "Compatible "WALKMAN" models"). Insert the tab on the left side of the attachment (A) into the left slot in the "WALKMAN" connector, and then press down into the unit (B). display, press ALARM TIME SET A or B again. Example: The following display appears when you preset FM 105. 8 MHz to preset number 1 for FM. Setting the buzzer alarm 1 Perform steps 1 to 8 in "To set the 2 Press ALARM TIME SET A or B to select alarm. " "BUZZER" alarm mode. The setting is entered. 2 Press AUDIO IN to display "AUDIO IN. " 3 Play the equipment connected to the 4 Adjust the volume using VOLUME + or ­ (VOL + or ­ on the remote). To return to the radio Press RADIO BAND. The frequency is shown in the display. AUDIO IN jack. To use the unit as a battery charger You can use the unit as a battery charger. Charging begins when the "WALKMAN" or Sony Ericsson Phone is connected to the unit. Charging status appears in the "WALKMAN" or Sony Ericsson Phone display. [. . . ] Rotate the aerial horizontally for optimum reception. Press ALARM TIME SET A or B to turn off the alarm A or B indicator from the display. When Daylight Saving Time (summer time) begins This model automatically adjusts for Daylight Saving Time (summer time). " " is displayed from the beginning of Daylight Saving Time (summer time) and disappears at the end of Daylight Saving Time (summer time) automatically. Automatic DST/Summer Time adjustment is based on GMT (Greenwich Mean Time). Daylight Saving Time (summer time) begins at: 1:00 AM on the final Sunday of March. [. . . ]