User manual SONY ICF-34

[. . . ] To disconnect the power cord, pull it out by the plug, not the cord. ⷠDo not place the unit on surfaces (rugs, blankets, etc. ) or near materials (curtains, draperies) that block the ventilation holes. ⷠShould anything fall into the unit, unplug the unit and have it checked by qualified personnel before operating it further. [. . . ] ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself is turned off. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. The Radio Controlled Clock Auto Adjust System receives the clock data (Year, month, date, hour, minute, second and D. Be sure to set the radio where reception would be easier. If the reception is incomplete after 12 minutes, the time setting will return to the original time and " " will disappear from the display. The changing of the summer time will be automatically changed by Clock Auto Adjust function. the change of summer time will have a time lag. Winter Time n Summer Time: about 1 hour and 10 minutes time lag. Summer Time n Winter Time: about 10 minutes time lag. There was a service interruption for more than 10 minutes, the alarm settings and clock settings has been resetted. To improve reception When the reception is poor, set the FM and Clock Auto Adjust antenna to a place and angle where the reception is much more stronger. The clock data that is sent has total of 60 units (this total unit is called 1 frame), the data is sent 1 unit for every second. This radio receives this data one by one from data No. 60, When the radio receives the first frame and then starts to receive the second frame for confirmation. When the 2nd frame has been confirmed, then the clock time data reception has been completed. When the unit is plugged in, this function will operate until the time receives completely. While holding down ALARM A or B, press TIME SET + or ­ until the desired time appears in the display. 1: 1 frame data when received 0: 1 frame data when not received 1: 1 unit data when received 0: 1 unit data when not received Maximum 10 hours displayed, even though the Clock Auto Adjust mode is not completed after 10 hours, the operation is still continued. [. . . ] 1: 1 frame data when received 0: 1 frame data when not received 1: 1 unit data when received 0: 1 unit data when not received Maximum 10 hours displayed, even though the Clock Auto Adjust mode is not completed after 10 hours, the operation is still continued. The radio or buzzer will automatically sound at the preset time, and automatically turn itself off after 60 minutes. To cancel the alarm before the alarm time, while holding down ALARM A or B, press ALARM RESET/OFF. The buzzer sound level is fixed, and independent of the VOLUME control. [. . . ]