User manual SONY ICF-C122

[. . . ] If it is used in temperatures outside this range, an irregular display may appear. If it is used in temperatures lower than this range, the display may change very slowly. These irregularities will disappear and there will be no damage to the unit when it is used in its recommended temperature range. ⷠDo not leave the unit in a location near heat sources, or in a place subject to direct sunlight, sand, excessive dust or mechanical shock. [. . . ] Failure to use the recommended AC power adaptor may cause the unit to malfunction. Sound quality is unsatisfactory, or reception is poor or cannot be received. Listen to the radio near a window when in a vehicle or building. The preset station cannot be received during preset tuning. ⷠYou did not select a page number by pressing MEMORY PRESET PAGE. The radio is not turned on when the preset standby time is reached. The preset standby time has been erased from memory because the batteries were not replaced within one minute after being removed from the unit. Slide HOLD to the left until "-" disappears from the display. The unit is being used in extremely high or low temperatures, or in a place subject to excessive moisture. The batteries are inserted with the + and ­ poles facing the wrong way. If you leave the radio for 30 seconds with no operation while the page number, preset number and "dEL" are flashing, the unit returns to the previous mode. Page number 1 and preset number 1 flash when you are presetting a station for the first time or when you have preset 50 stations. In other cases, the number flashes as follows: Page number: the smallest page number among the pages that have a free preset number Preset number: the smallest preset number that has not been preset in the page displayed above. When the standby time is reached while you are listening to the radio, the radio turns off and the alarm sounds. Enjoy falling asleep to the radio using sleep timer. The radio turns off automatically after the sleep timer setting (60, 45, 30 or 15 minutes) is reached. The radio turns on if it was turned off. Press the number under the MEMORY PRESET PAGE you have selected repeatedly to display the desired preset number. Keep the unit and antenna away from fluorescent lights, TVs, computers, and other equipment which may generate noise. Note that the SW active antenna AN-LP1 may not function as usual when it is connected to this radio and memory scan tuning is in use. This is because AN-LP1 selects frequencies by the antenna controller. Press SLEEP repeatedly to select the desired sleep timer setting while "SLEEP" is flashing. [. . . ] A doublebeep sounds if the smallest preset number is selected. A double-beep sounds when the minimum frequency of each band is received during tuning. When a broadcast is received, "p TUNE" is displayed on the display. Release the button when the frequency indication starts changing. [. . . ]