User manual SONY ICF-C370

[. . . ] ⷠWhen the casing becomes soiled, clean it with a soft cloth dampened with mild detergent solution. Never use abrasive cleansers or chemical solvents, as they may mar the casing. ⷠIn vehicles or buildings, radio reception may be difficult or noisy. If you have any questions or problem concerning your unit, please consult the nearest Sony dealer. [. . . ] ⷠWhen you press SLEEP/CLOCK while the timer has been activated, the elapsed time will be erased and the timer duration will begin from the start. ⷠYou can also set the current time through automatic synchronization with RDS data using the CT function. When traffic information is received, " " starts to flash, and the unit switches over to the traffic information. For locating a station when its frequency is not known. In this radio, the following functions are available for receiving RDS data: To stop the reception of traffic information and to return to your tuned-in station, press TRAFFIC INFO. If the tuned-in station is not a traffic information station nor a station in an EON network, a beep sounds. ⷠSwitching the band from FM to AM while " " is lit in the display causes " " to " does not come back on disappear. " when the band is switched back to FM or if the unit is turned off and then on again. ⷠWhen POWER is turned off, traffic information will not be received. Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The front panel buttons do not operate at all. Please buy an AC power adaptor suitable in the country where the radio is to be used. When you tune in to an FM station, the display may change from the frequency readout to the name of the station. This happens particularly for FM stations that carry RDS data in their frequencies. Press and hold down ALTERNATIVE SEARCH until the unit locates a better reception. Install two R6 (size AA) batteries (not supplied) with correct polarity. If the unit does not receive CT data after 2 minutes, "NO CT" appears in the display. The current time on your unit, set through this mode, will be as accurate as that of the CT data received. ⷠThe CT function may not work in some areas or on certain frequencies. You can change the display mode by setting the STATION NAME switch to either CLOCK or STATION. sTATION NAME switch set to CLOCK: · When you turn on the power, the display shows the tuned-in frequency for a few seconds, and then switches to the current time while the radio is on. You can tune in to a station by turning TUNE/ TIME SET to the desired frequency. [. . . ] When you operate your unit while the light is on, the light stays on for longer than 10 seconds. When the batteries are weak, the sound becomes weak and distorted. When the batteries are completely exhausted, the radio is inoperative and "i" appears in the display. Once "i" comes on in the display, it remains even after new batteries are installed. [. . . ]