User manual SONY ICF-C780

[. . . ] Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. [. . . ] Check that the buzzer, radio or melody alarm is activated (the ALARM A (or B) indicator lights up). The radio alarm is activated but does not sound at the preset alarm time. Check that the volume is not set to minimum. When daylight saving time begins, the clock does not employ the daylight saving time automatically. Press and hold DST for at least 3 seconds to activate the automatic DST/summer time adjustment. For the state of california, USA only Perchlorate Material ­special handling may apply, See www. dtsc. ca. gov/hazardouswaste/perchlorate Perchlorate Material: Lithium battery contains perchlorate INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. While setting the alarm time, the ALARM A (or B) indicator flashes in the display. The following example is when setting the ALARM A. 3 Press TIME ZONE repeatedly until the AC power cord desired number appears. There is a tactile dot above the VOLUME dial to indicate which way turns the volume up. The display returns to the clock about 4 seconds after the operation is complete. Note During the shipment and your first use, a clock error may occur. In this case, refer to "Setting the clock and date" to set the correct time. Setting the brightness of the display Three levels of brightness are available by pressing BRIGHTNESS. When the alarm time setting is complete, the display returns to the clock after a few seconds and the ALARM A (or B) indicator changes from flashing to fully lit. While ALARM A (or B) is set to , RADIO or MELODY, the alarm time setting can be changed by ALARM TIME SET A (or B) + or ­. One press of ALARM TIME SET A (or B) + or ­ displays the alarm time for about 4 seconds. By pressing ALARM TIME SET A (or B) + or ­ while the alarm time appears in the display, the alarm time will be changed. For the buzzer alarm, the beeping of the alarm becomes more rapid after every few seconds in three progressive stages. The ALARM A (or B) indicator flashes in the display while: ­ The alarm time appears in the display. The alarm time setting cannot be changed if ALARM A (or B) is set to OFF. If you press ALARM TIME SET A (or B) + or ­, "OFF" appears in the display for about 0. 5 seconds. [. . . ] Notes Daylight Saving Time depends on the law in each country/region, and your area may not use it. In such a case, cancel the automatic DST/ summer time adjustment before using the set and set the time manually as necessary. To activate the automatic DST/summer time adjustment again, press and hold DST for at least 3 seconds. A beep sounds, and "Aut On" appears in the display to show that the automatic DST/summer time adjustment is activated. [. . . ]