User manual SONY ICF-CD810

[. . . ] ⷠSelf power back-up: Even if the power supply is interrupted, the time setting and the memory will be backed up for 1 minute without batteries. Do not install the appliance near sources of heat such as radiators, heat registers, stoves, or other appliances that produce heat. Slots and openings in the cabinet and in the back or bottom are provided for necessary ventilation. To ensure reliable and safe operation of the appliance, and to protect it from overheating, these slots and openings must never be blocked or covered. [. . . ] To disconnect the cord, pull it out by grasping the plug. The model number and the serial number are located on the rear. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Be careful that foreign objects and liquids do not enter the enclosure through openings. CD player section System: Compact disc digital audio system Laser diode properties: Material: GaAlAs Wavelength: 780 nm Emission duration: Continuous Laser output: Less than 44. 6 µW* *This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture. Clean the appliance only as recommended by Sony. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. wHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM , EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. 7 kg (3 lb 12 oz) Design and specifications are subject to change without notice. Unplug the appliance from the wall outlet and consult qualified service personnel when: -the power cord or the plug has been damaged. Do not attempt to service the appliance beyond that described in the operating instructions. After 10 seconds, the indication becomes the current time but the "RADIO" indication remains. If you want to keep on listening to radio and stop flashing, press RADIO/SLEEP. The buzzer sound level is fixed, and independent of VOLUME. To Doze for a Few More Minutes The CD, radio or buzzer will shut off but will be activated automatically after about 8 minutes. You can repeat this process as many times as necessary. You can fall asleep to the radio and you will be awakened by the CD, radio or buzzer alarm at the preset time. Before setting the alarm, be sure to set the clock. [. . . ] When you set the CD alarm, if there is no disc in the CD player, the buzzer will sound at the time you set. ⷠThe selected alarm is activated at the time you set, and automatically turns off after 60 minutes. ⷠWhen the CD alarm comes on, the " " indication flashes. if you want to stop flashing , press CD fl. [. . . ]