User manual SONY ICF-CD831

[. . . ] The disc should be placed with the labeled side up. · Dusty or defective disc -- Clean the disc with an optional cleaning cloth. · Take out the CD and leave the CD compartment open for about an hour to remove moisture condensation. · Dusty or defective disc -- Clean or replace the disc. [. . . ] Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. Before You Begin Thank you for choosing the Sony CD clock radio!It will give you many hours of reliable service and listening pleasure. Before operating the unit, please read these instructions thoroughly and retain them for future reference. Dimensions: Approx. 229 × 104 × 218 mm(w/h/d) (Approx. 9 1 /8 × 4 1/8 × 8 5/8 inches) incl. projecting parts and controls Mass: Approx. 1 650 g (3 lb 10 oz) Design and specifications are subject to change without notice. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Features · Built-in CD player with CD-R/RW playback function · Easy to see large green LED display with brightness control function · Wake to any track of a CD, Radio or Buzzer (dual alarm) · Easy nap timer -one push operation · Extendable snooze time from 10 to 60 minutes · Various CD play modes with Shuffle/Repeat function Antenna Grounding According to the National Electrical Code Antenna Lead-in Wire Ground Clamps Electric Service Equipment NEC-NATIONAL ELECTRICAL CODE Antenna Discharge Unit (NEC Section 810-20) Grounding Conductors (NEC Section 810-20) Ground Clamps Power Service Grounding Electrode System (NEC Art 250 Part H) Precautions · Operate the unit on the power source specified in the "Specifications. " · The nameplate indicating operating voltage, etc. · To disconnect the power cord (mains lead), pull it out by the plug, not the cord. · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. · Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. · To clean the casing, use a soft cloth dampened with a mild detergent solution. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. SERVICE Damage Requiring Service Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions: -When the power cord or plug is damage or frayed. -If liquid has been spilled or objects have fallen into the appliance. -If the appliance has been exposed to rain or water. -The appliance does not appear to operate normally or exhibits a marked change in performance. [. . . ] Set the ALARM MODE selector to CD, RADIO or BUZZER. The ALARM A or ALARM B indicator lights up. Press ALARM SET A or ALARM SET B for a few seconds. The ALARM A or ALARM B indicator flashes, depending on which one you set. After one beep, the hour will start to flash in the display. Using the NAP Timer (Count Down Timer) The NAP timer sounds the buzzer after a present time duration. [. . . ]