User manual SONY ICF-CD833

[. . . ] For those appliances designed to operate from battery power, or other sources, refer to the operating instructions. Grounding or Polarization This appliance is equipped with a polarized AC power cord plug (a plug having one blade wider than the other), or with a three-wire grounding type plug (a plug having a third pin for grounding). Follow the instructions below: -For the appliance with a polarized AC power cord plug: WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. * The graphical symbols are on the bottom enclosure. This plug will fit into the power outlet only one way. [. . . ] Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. WARNING You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. When it is set to HOLD, you cannot see the red label underneath. TUNE BAND FM AM 4 ALARM VOL LOW HIGH Set the ALARM MODE switch to RADIO, BUZZER or RADIO+BUZZER. The ALARM RADIO or ALARM BUZZER indicator lights up. When you set both alarm times, both ALARM RADIO and ALARM BUZZER indicators light up. Specifications Time display 12-hour system Frequency range FM : 87. 5 - 108 MHz AM : 530 - 1 710 kHz Speaker Approx. 8 Power output 120 mW (at 10 % harmonic distortion) Power requirements 120 V AC, 60 Hz For power backup: 9 V DC, one 6F22 battery Battery life Approx. 9 hours (for clock and alarm backup) using Sony 006P (6F22) battery Dimensions Approx. 198. 7 × 101. 5 × 109. 7 mm (w/h/d) (7 7/8 × 4 × 4 3/8 inches) not incl. projecting parts and controls Mass Approx. battery Design and specifications are subject to change without notice. AM BRIGHT NESS HIGH RADIO ALARM The alarm will come on at the preset time and will automatically turn itself off after about 59 minutes. If the same alarm time is set for both RADIO and BUZZER, RADIO will take priority. To check the alarm setting Set the ALARM TIME/CLOCK SET switch to RADIO or BUZZER. LOW PM BUZZER To Doze for a Few More Minutes Press SNOOZE. The radio or buzzer turns off but will automatically come on again after about 6 minutes. You can repeat this process as many times as you like. OFF RAD IO BU ZZER RA DIO+BUZZE R RADIO ON RADIO O FF SLE EP To Stop the Alarm Press ALARM RESET·RADIO OFF to turn off the alarm. [. . . ] Halogenated flame retardants are not used in printed wiring boards. Features · · · · · · Easy to-see Large 1. 4 inch green LED Alarm Vol. Control (High/Low) Dual alarm (radio alarm and buzzer alarm) Easy to-see alarm indicator Variable brightness control Full power backup to keep the clock and the alarm (radio and buzzer) operating during a power interruption with a 6F22 battery (not supplied) installed. Setting the Clock 1 2 3 Plug in the unit. The display will flash "AM 12:00". To Adjust the Alarm Level (ALARM VOL) Select the volume of the alarm by setting ALARM VOL to HIGH or LOW. Set the ALARM TIME/CLOCK SET switch to CLOCK. Press FAST+, FAST­ or + to adjust the time. When you press FAST+, the time is raised rapidly. When you press FAST­, the time is lowered rapidly. [. . . ]