User manual SONY ICF-CS750

[. . . ] Never use abrasive cleaners or chemical solvents, as they may mar the casing. ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. If you have any questions, please consult your nearest Sony dealer. The Dream Machine will give you many hours of reliable service and listening pleasure. [. . . ] These instructions cover these models: ICF-C723 and ICF-CS750. The band and frequency will appear in the display for a few seconds and then the current time indication returns to the display. 1 MHz and the AM channel step is set to l0 kHz for the model for the North and South America. 05 MHz and the AM(MW) channel step is set to 9 kHz for the model for other countries. A beep sounds when the upper or lower extremity of the band range is reached. Only one message can be recorded and up to about 20 seconds. ⷠIf you want to keep the recorded message, be careful not press the VOICE MEMO· The volume cannot be adjusted for the voice memo. Digital voice memo which you can also use for the wake up memo mode. ⷠDate button to display the year, month and date. LCD with backlight which has a brightness switch. ⷠSelf power back-up: Even if the power supply is interrupted, the time setting and the memory will be back up for half an hour without batteries. Each time you press ALARM MODE, the alarm indication changes as follows. When the alarm time is reached, the radio or buzzer sounds for 60 minutes or until turned off. Should any problem occur with the unit, make the following simple checks to determine whether or not servicing is required. if the problem persists , consult the nearest Sony dealer. The clock does not show the correct time. ⷠHas an electrical power outage lasting more than half an hour occurred?To display the year and date, press SNOOZE/ DATE/SLEEP OFF once for the date and within 2 seconds press it again for the year. The date or year will appear in the display for a few seconds and then the display returns to the current time. When SNOOZE/DATE/SLEEP OFF is pressed while the SNOOZE function is operating, the year and date will not appear in the display. To set the current time from zero seconds, release CLOCK with the time signal at step 5. SELECT/PRESET button (in this case, 2) until you hear two short beeps. [. . . ] 12 hour 24 hour The frequency will appear for a few seconds and then the display will return to the current time. ⷠWhen using the radio alarm, preset the station you wish to serve as the alarm under preset button 1. Press ALARM MODE until neither the "A RADIO" nor "B BUZZER" indication is displayed. notes · The alarm does not function, unless you set the clock, A RADIO and B BUZZER function. [. . . ]