User manual SONY ICF-M88B

[. . . ] 3-267-406-11(1) Battery Life (Approx. hours) (JEITA*) FM 66 23 AM 84 31 Features · · · · · · · · FM/AM PLL(phase locked loop) synthesized radio with built in cycle-computer New ergonomic design Water-resistant for all-weather use 15 station memory presets (10FM/5AM) Easy Jog lever operation Easy to see backlit LCD Easy to install mounting kit included FM SENS DX(Distance)/LOCAL switch 4 When using Sony alkaline size AA (LR6) Sony size AA (R6) Temporarily attach the Sensor to a fork using the attached Double-sided tape. Sensor FM/AM PLL Synthesized Radio Operating Instructions * Measured by JEITA (Japan Electronics and Information Technology Industries Association) standards. The actual battery life may vary depending on circumstances of use. Replace the batteries When the batteries become weak, the sound may become weak or distorted, and "E" will flash in the display. After that, when the batteries are used up, "E" will light up and clock time display appears. [. . . ] Caution For safe and proper use of the cycle-computer, check whether the Mount, the sensor and its cord and the wheel magnet are set properly before riding. INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. 2 Screw * Packing inside of the lid is used to ensure water-resistance for the battery compartment. Therefore, make sure to close the battery compartment lid securely. 2 Close the lid. OPEN OPEN Size AA (R6) × 2 Insert the # side of the battery first. 1 3 Wind the sensor cord around the break cable. Mount Sensor cord Note Be sure to allow enough cord slack to ensure full movement and unhindered operation of the handlebar, and not to wind it too loosely as this may interfere with the unit's operation. FREEZE FM AM AM PM PRESET MHz kHz MPH km/h inch mm MPH km/h mile Displaying data While cycling, current speed is always displayed and updated every second. Standby mode When your bicycle is stopped with the radio off, and no button is pressed for more than 10 minutes, the cycle-computer enters Standby mode, and only the current time is displayed. Presetting your Favorite Stations -- Preset Tuning You can preset up to 5 AM stations, and 10 FM stations. You can also delete a preset station, whether factory-set or preset yourself. RADIO POWER LIGHT ENTER/SELECT TUNE MODE BAND/SET To cancel Standby mode When the unit is attached to the Mount At the point where you start and the magnet passes the sensor, or you press any active button, Standby mode is canceled. (The display returns to the previous one before entering Standby mode. ) When the unit is not attached to the Mount When you attach the unit to the Mount or press any active button, Standby mode is canceled. Note If the cycle-computer enters Standby mode with Freeze mode activated, Freeze mode is not canceled. CLOCK ODO DIST RT AVG MAX The highest speed that can be displayed is 124. 2 MPH (199. 9 km/h) and remains displayed beyond that speed. Below 2. 5 MPH (4. 0 km/h), 0. 0 is displayed. Presetting a Station 1 2 Displaying the odometer RAD IO P OWE R LIG HT ENT Press MODE/FREEZE repeatedly until "ODO" appears. The current total distance is displayed. E R/SE Follow steps 1 to 5 in "Playing the Radio" and manually tune in to the station you wish to preset. Hold down ENTER/SELECT until the preset number flashes. A preset number with no station will flash. When all preset numbers have assigned stations (factory-set), "1" flashes and "PRESET" appears. LECT TUNE MODE BAND/SET VOL Jog lever Note If 99 999. 9 miles (160 934. 3 km) is exceeded, the odometer returns to zero. Using the Backlight Displaying trip distance Press MODE/FREEZE repeatedly until "DIST" appears. At the point you want to start calculating the distance, perform the zero reset operation. For details on how to perform the zero reset operation, refer to "Performing the zero reset. " Press LIGHT. The backlight will light for 10 seconds. If any buttons are pressed while the backlight is on, the backlight will turn off 10 seconds after pressing the button. 3 Push the Jog lever towards + or ­ to select the number you wish to preset, then press ENTER/SELECT. If a preset number you select with the Jog lever has an assigned preset station, "PRESET" appears; if no station is assigned, only the number flashes. When you press ENTER/SELECT, the selected preset number lights up in the display. Note If the displayed "99:59:59" is exceeded, riding time returns to zero. g 5 Repeat step 4 above to adjust the minutes. ":" starts flashing and the clock starts operating. [. . . ] Pressing and holding selects the Station-presetting mode. TUNE/MODE : Pressing this button displays the current frequency. Pressing and holding selects preset station deleting mode in preset tuning mode. In manual tuning mode, holding down has no effect. [. . . ]