User manual SONY ICF-SW800

[. . . ] To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. Precautions · Operate the unit on the power source specified in the "Specifications. " · The nameplate indicating operating voltage, etc. · To disconnect the power cord (mains lead), pull it out by the plug, not the cord. · Do not leave the unit in a location near a heat source, such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. [. . . ] Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone Number: 201-930-6972 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. CAUTION The use of optical instruments with this product will increase eye hazard. -For the appliance with a polarized AC power cord plug: This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized plug by forcing it in. -For the appliance with a three-wire grounding type AC plug: This plug will only fit into a grounding-type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. You can only check the alarm setting when it is activated. If you set the CD alarm and there is no disc in the CD player, the buzzer alarm will sound in its place at the time set. For the alarm, the beeping of the alarm becomes more rapid after every few seconds in three progressive stages. When headphones (not supplied) are plugged into the unit, the alarm will not sound through the speakers regardless of the alarm mode setting. Note When Alarm A and Alarm B are set for the same time, the Alarm A takes precedence. 3 BUZZER LOW Use TUNE·TIME SET + or ­ to tune into a station. Two short beeps sound when the minimum frequency of each band is received during tuning. 2 Press TUNE·TIME SET + or ­ until the desired hour appears. To set the hour rapidly, hold down TUNE·TIME SET + or ­. ALARM B About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs but playback capability may vary depending on the quality of the disc, the recording device and application software. 4 Adjust volume using VOL + or ­. 3 4 5 Press ALARM A or B. After one beep, the minutes will flash. PRESET TUNING 1 NAP i 2 (headphones) jack FM wire antenna SLEEP Music discs encoded with copyright protection technologies This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. To handle compact discs Correct When you release TUNE·TIME SET + or ­ after locating your desired station, the display returns to the previous display after about 10 seconds. To check the frequency of the tuned-in station, press RADIO ON·BAND and the frequency appears for about 10 seconds. To turn off the radio, press OFF x·ALARM RESET. Repeat step 2 to set the minutes and press ALARM A or B. After one beep, the alarm mode is entered. Press TUNE·TIME SET + or ­ until the desired alarm indicator flashes. You can choose one mode among "CD, " "RADIO" and "BUZZER. " Set the alarm mode as follows: ­ CD: see "A Setting the CD Alarm. " ­ RADIO: see "B Setting the Radio Alarm. " ­ BUZZER: see "C Setting the Buzzer Alarm. " To Doze for a Few More Minutes Press SNOOZE·SLEEP OFF. The CD, radio or buzzer alarm turns off but will be automatically activated again after about 10 minutes. [. . . ] After setting the minutes, press CLOCK to start the clock, and you will hear two short beeps. 1 2 Push PUSH OPEN to open the CD compartment lid and place a disc. Push PUSH CLOSE to close the CD compartment lid. The frequency remains on the display for about 10 seconds and then returns to the previous display. To preset another station, repeat these steps. To change the preset station, tune into the desired station and hold down the PRESET TUNING 1 to 5 button. [. . . ]