User manual SONY IPT-DS1

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] ¦ Note When removing the batteries, be careful they do not fall and cause injury. ¼ Tip Remove the batteries if this unit will not be used for a long period of time. If the battery level is low, the operation/battery indicator flashes slowly. If the battery level gets lower, indicator flashes more rapidly and this unit automatically enters standby mode. The internal memory and memory card have sufficient free space. install a fully charged battery pack into the camera. 2 Press the release button (dark gray) of this unit to open the camera clips. Attachment A models according to the table of compatible models Position the camera with its lens facing the SONY logo on this unit. Attachment B models according to the table of compatible models Position the camera with its LCD screen facing the SONY logo on this unit. 4 Align the multi connector at the bottom of the camera with the multi connector on this unit. 5 Slide the camera slowly until it is positioned almost at the center of this unit. ¼ Tip When "To stop shooting, press Shooting button on Party-shot" is displayed on the LCD of your camera, press the On-demand shot button of this unit. Shooting using On-demand shot function On-demand shot is a function that lets you send recording instructions to the unit at any time you like. You can send instructions to record not only still images but also Intelligent Sweep Panorama shots using the pan function of this unit. Press the On-demand shot button during automatic shooting or setting screen display. When the camera detects a face and finishes choosing the composition, there is a fast beeping and shooting begins. After finishing the On-demand shot, this unit returns to automatic shooting mode. ⦠Notes There is no beep if the camera is set to mute. Pressing the button too strongly may cause this unit to fall off the dedicated stand. ¼ Tips Even if the camera cannot find a face, it takes a shot. To cancel On-demand shot during operation, press the On-demand shot button once more. On panorama shooting, you cannot cancel On-demand shot after the composition is set. [. . . ] Use the dedicated stand in a level place. Do not apply a strong force to the dedicated stand. Pressing the button too strongly may cause this unit to fall off the dedicated stand. Hold the camera when operating it to prevent it from falling and causing injury. [. . . ]