User manual SONY KD-28DX40U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Press the V or v button to select your choice of wall paper followed by the OK button to store. This feature allows you to set an age limit for programmes on the TV. If any films or programmes classed above the age limit you have set are broadcast, you will be requested to enter your PIN code before viewing is allowed. In order to use the `Parental Control' feature you must first set your PIN code. If you have not already set a PIN code: Using the numbered buttons on the remote control, enter a 4-digit number of your choice. As you enter each digit it will be represented by a * in the PIN entry box. Note: This will be your PIN number for the future - please use a number you can easily remember. If you have already set a PIN code: Using the numbered buttons on the remote control, enter your 4-digit PIN code. As you enter each digit it will be represented by a * in the PIN entry box. With the `Age' box highlighted, press the V or v button to set the age limit you desire then press the OK button to confirm your setting. This feature allows you to automatically re-tune all available Digital channels. The `Detail Set-up' menu allows you to further customise your TV with the following features: This feature allows you to select a channel number from the displayed list and change the digital services of that channel. Press the V or v button to highlight the chosen channel number for your new channel. If you do not wish to select any of the programme numbers listed, press the RED or GREEN button to display the previous or next 5 programme numbers on the list. With your channel number highlighted, press the OK button to display the `Manual Programme Search' screen. Press the V or v button if you wish to change the channel number, then press the b button to make the select search box active. The words `Searching Down' or `Searching Up' appear in the select search box to indicate that the TV is searching. If no Digital services are found on the channel you have chosen, the channel number changes up or down automatically and the search continues. When all services allocated to the selected channel have been found, the service selection screen is displayed. Press the V or v button to find and highlight the service you wish to allocate to the channel number selected in Step 4, then press the OK button to display the channel selection screen. Repeat Steps 4 to 8 if you wish to manually add more channels to your TV. Press the BLUE button on the remote control three times to remove the `Digital INFO display' from the TV screen. [. . . ] When you wish to use the remote control to operate the TV again, press the Media Select button until the TV green light illuminates. Don't forget to select VCR or DVD using the Media Select button every time you wish to operate that equipment with this remote control. Note: The brand codes you set may be lost if weak batteries are not replaced immediately. Should this happen, use the above procedure to re-enter the code. [. . . ]