User manual SONY KDL-32D2810

[. . . ] When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] A display appears to confirm that you want to delete all channels from the Favourite list. Switch on the connected equipment, then perform one of the following operation. For equipment connected to the scart sockets using a fully-wired 21-pin scart lead (page 40) Start playback on the connected equipment. For other connected equipment (page 39) Press / repeatedly until the correct input symbol (see below) appears on the screen. AV4: Component input signal through the Y, PB/CB, PR/CR sockets / 4, and audio input signal through the L (MONO), R sockets / 4. Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket. aV7/ AV7/ AV7: Input symbols appear depending on the connected equipment and the "AV7 Input" setting in the "AV Setup" menu (page 31). AV7: Component input signal through the Y, PB/CB, 7, and audio input signal through the PR/CR sockets audio L (MONO)/R sockets 7. AV7: Composite input signal through the video socket 7, and audio input signal through the audio L (MONO)/R sockets 7. AV7: S video input signal through the S video socket 7, and audio input signal through the audio L (MONO)/R sockets 7. PC: PC video input signal through the PC socket, and audio input signal through the PC audio socket . As you move the z to the right along the "Clarity" axis, the picture becomes smoother. "DRC Palette" is not available when "Game Mode" is set to "On", "DRC Mode" is set to "Off" or when using Freeze or PAP features; also not available when watching 480p, 576p, 720p, 1080i or 1080p sources. When you set "Picture Mode" to "Custom", you can set/change these settings. This setting is especially effective for dark images, increasing vibrancy in the picture. "Gamma": Adjusts the balance between bright and dark areas of the picture. Contrast Enhancer" and "Detail Enhancer" are not available when using Freeze or PAP features. â· "Live Colour" is not available when "Colour Space" is set to "Normal". You can select the options listed below on the Sound menu. For the input currently being viewed, select whether to use the common setting or to set each item separately. "Common": Applies common settings whose adjustments are shared with other inputs in which "Target Inputs" is set to "Common". AV1): Allows you to set each option separately for the current input. [. . . ] Press and hold the DVD, VCR or AMP function button you want to programme on the remote, then press , keeping the function button pressed down. Press the number buttons to enter the three-digit manufacturer's code number while the button is lit. If code is not entered within 10 seconds, you must perform the step 1 again. When the programming is correct, the selected function button will flash twice, and when not, it will flash five times. [. . . ]