User manual SONY KDL-40S2530 annexe 1

[. . . ] Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. or data integrity reasons require a permanent connection with an incorporated battery, this battery should be replaced by qualified service staff only. To ensure that the battery will be treated properly, hand over the product at end-of-life to the applicable collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. [. . . ] ­ OPTIONS to display "Device Control", then select options from "Menu", "Options", and "Content List" to operate the equipment. ­ Refer to the instruction manual of the equipment for available control. Selection" is displayed when the button is pressed. ~ · Control for HDMI (BRAVIA Sync) is only available with the connected Sony equipment that has the BRAVIA Sync logo or is compatible with control for HDMI. · Sony BRAVIA Theatre Sync Products and Control for HDMI compatible devices from other manufacturers may not support all functions. To connect the equipment that is compatible with control for HDMI Connect the compatible equipment and the TV with a HDMI cable. When connecting an audio system, be sure to also connect the DIGITAL AUDIO OUT (OPTICAL) socket of the TV and the audio system using an optical audio cable. To make the control for HDMI settings The control for HDMI settings must be set on both the TV side and connected equipment side. See HDMI Set-up on page 27 for the TV side settings. For settings on the connected equipment, refer to the operating instructions for that equipment. Buttons for using optional equipment GUIDE 1 m/N/X/M/x: You can operate the BRAVIA Sync-compatible equipment that is connected to the TV. 2 THEATRE You can set Theatre Mode on or off. When Theatre Mode is set to on, the optimum audio output (if the TV is connected with an audio system using an HDMI cable) and picture quality for film-based contents are automatically set. z If you turn the TV off, Theatre Mode is also turned off. 3 SYNC MENU: Displays the menu of connected HDMI equipment. "Text": For text, charts or tables. Display Mode (only in PC mode/ PC Input/ HDMI PC Input) Reset Backlight Contrast Brightness Colour Hue Resets all picture settings except "Picture Mode" and "Display Mode" (only in PC mode) to the factory settings. Adjusts the brightness of the backlight. Increases or decreases picture contrast. Increases or decreases colour intensity. Increases or decreases the green and red tones. z "Hue" can only be adjusted for an NTSC colour signal (e. g. , U. S. A. video tapes). Colour Temperature Adjusts the whiteness of the picture. "Cool": Gives the white colours a blue tint. "Neutral": Gives the white colours a neutral tint. "Warm 1/Warm 2": Gives white colours a red tint. "Warm 2" gives a redder tint than "Warm 1" z "Warm 1 and Warm 2" are not available when "Picture Mode" is set to "Vivid". Sharpness Noise Reduction Sharpens or softens the picture. Reduces the picture noise (snowy picture) in a weak broadcast signal. [. . . ] · If the 1 (standby) indicator lights up in red, press "/1. No picture or no menu information from equipment connected to the scart connector · Press / to display the connected equipment list, then select the desired input. · Check the connection between the optional equipment and the TV. Double images or ghosting (only in analogue mode) · Check the aerial/cable connection. [. . . ]