User manual SONY KDL-46S2000

[. . . ] When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] The following icons may be indicated on the banner. You can set VCR timer recording on the TV only for Smartlink compatible VCRs. If your VCR is not Smartlink compatible, a message will be displayed to remind you to set your VCR timer. ⷠOnce a recording has begun, you can switch the TV to standby mode, but do not switch off the TV completely or the recording may be cancelled. Set a programme to be displayed automatically on the screen when it starts ­ Reminder Do this 1 2 3 4 Press M/m/</, to select the future programme you want to display. Note If you switch the TV to standby mode, it will automatically turn itself on when the programme is about to start. Set the time and date of a programme you want to record ­ Manual timer REC Set the start and stop time in the same way as in step 3. Press M/m to select the channel, then press OK to set the TV and your VCR timers. You can set VCR timer recording on the TV only for Smartlink compatible VCRs. If your VCR is not Smartlink compatible, a message will be displayed to remind you to set your VCR timer. ⷠOnce a recording has begun, you can switch the TV to standby mode, but do not switch off the TV completely or the recording may be cancelled. You can select the options listed below on the Picture Adjustment menu. When you set "Mode" to "Vivid" or "Standard", you can adjust only "Mode", "Contrast", "Colour Tone", "Noise Reduction", and "Reset". Press M/m to select one of the following picture modes, then press OK. Custom: Allows you to store your preferred settings. tip You can also change the picture mode by pressing repeatedly. Press </, to set the level, then press OK. Press M/m to select one of the following, then press OK. Cool: Gives the white colours a blue tint. Reduces the picture noise (snowy picture) in a weak broadcast signal. Press M/m to select one of the following, then press OK. CNR: Reduces the picture noise when the animation image is received. [. . . ] tip A small label is provided inside the battery door to allow you to record your brand codes. Not all brands are covered and not all models of every brand may be covered. Design and specifications are subject to change without notice. 1 Count how many 1 (standby) indicator flashes between each two second break. [. . . ]