User manual SONY BRAVIA KDL-46XBR8

[. . . ] When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] After aerial and other equipment connections are completed, be sure to attach the supplied clamp screws to the rear of the TV, and thread a sturdy cord or chain through it and attach it to a wall or pillar. Remove one of the two screws on the rear of the TV, then install the supplied clamp screw in the screw hole. Repeat step 1 to install the other clamp screw. Attach a sturdy cord or chain securely to each clamp screw, and attach the cord or chain to a wall or pillar. The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen, 2) choose the country/region in which you want to operate the TV, 3) search and store all available channels (TV Broadcast), and 4) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do so by selecting the appropriate option in the "Set Up" menu (see page 40). The first time you switch on the TV, the Language menu appears automatically on the screen (Auto Startup). Press / / or on the remote control to select the language, then press OK to confirm your selection. Press or to select the country/region in which you will operate the TV, then press OK to confirm your selection. If the country/region in which you want to use the TV does not appear in the list, select "­" instead of a country/region. Please be patient and do not press any buttons, otherwise the auto tuning will not be completed properly. On/Off Volume level of the channels will stay the same, independent of the broadcast signal (e. When the "Speaker" option in the "Features" menu is set to "Centre in, " the options in the "Sound Adjustment" menu cannot be adjusted. A/B/Mono For a bilingual broadcast, select A for sound channel 1, B for sound channel 2, or Mono for a mono channel, if available. If you select other equipment connected to the TV, set the Dual Sound option to Stereo, A, or B. Even if headphones are connected to the TV, you can hear the sound from the TV speakers. A/B/Mono For a bilingual broadcast, select A for sound channel 1, B for sound channel 2, or Mono for a mono channel, if available. ⷠIf you select other equipment connected to the TV, set the i Dual Sound option to Stereo, A, or B. ⷠI Dual Sound works in conjunction with "Dual Sound. " Reset Cancel/OK Select OK to reset the sound to the factory preset. Only "Treble, " "Bass, " and "Balance" are restored to the factory settings when you reset the sound. 2 Press or to select On (if you want the TV to automatically switch the screen format according to the video input signal) or Off (if you want to keep your preference). [. . . ] ⷠKeep the aerial cable away from other connecting cables. ⷠDo not use 300-ohm twin lead cables as interference may occur. ⷠMake sure that the output signal of the equipment connected to the Scart connector / S 3 is not an RGB signal. Check if any connected optional equipment is installed in front of the TV or beside the TV. [. . . ]