User manual SONY KDL-S40A11E

[. . . ] Before operating the TV, please read the "Safety information" section of this manual. Retain this manual for future reference. To prevent the risk of electric shock, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed. [. . . ] Press m/M to select the channel you want to add, then press OK. If there are more than five channels in the list, press the green button for the next five channels or press the red button for the previous five channels. If you know the channel number, you can use the number buttons to directly select a channel. Channels that are stored in the Favourite list are indicated by a symbol. Turn off the Favourite list Move through in the Favourite list Display the previous or next five channels See brief details on current programmes Watch a channel Add or remove channels in the Favourite list Channels that are stored in the Favourite list are indicated by a symbol. If there are more than five channels in the list, press the green button for the next five channels or press the red button for the previous five channels. If you know the channel number, you can use the number buttons to directly select a channel. Press the blue button to return to the Favourite list. A display appears to confirm that you want to delete all channels from the Favourite list. Switch on the connected equipment, then perform one of the following operation. For equipment connected to the scart sockets using a fully-wired 21-pin scart lead Start playback on the connected equipment. You can also press / repeatedly until the correct input symbol (see below) appears on the screen. For other connected equipment Press / repeatedly until the correct input symbol (see below) appears on the screen or press OK to access the Input signal index table. 3: Component input signal through the Y, PB/CB, PR/CR sockets / 3, and audio input signal through the L/G/S/I, R/D/D/D sockets / 3. 4/ 4: Video input signal through the video socket 4, and audio input signal through the audio socket L/G/S/I (MONO), R/D/D/D sockets 4. Appears only if the equipment is connected to the S video socket 4 instead of the video socket 4, and S video input signal is input through the S video socket 4. 5: RGB input signal through the PC connectors audio input signal through the socket . Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket. The following options are available in each menu. You can select the options listed below on the Picture Adjustment menu. When you set the "Picture Mode" option to "Vivid" or "Standard, " you can adjust only "Contrast, " and "Reset. Press m/M to select one of the following picture modes, then press OK. [. . . ] This TV does not support Sync on Green or Composite Sync. If a signal other than in the above chart is input, it may not be displayed properly or may not be displayed as you set. 1 Measure how long the 1 (standby) indicator flashes and stops flashing. For example, the indicator flashes for two seconds, stops flashing for one second, and flashes for two seconds. [. . . ]