User manual SONY KDL-V40A11E

[. . . ] Before operating the TV, please read the "Safety information" section of this manual. Retain this manual for future reference. To prevent the risk of electric shock, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed. [. . . ] If there are more than five channels in the list, press the green button for the next five channels or press the red button for the previous five channels. If you know the channel number, you can use the number buttons to directly select a channel. Press the blue button to return to the Favourite list. A display appears to confirm that you want to delete all channels from the Favourite list. Switch on the connected equipment, then perform one of the following operation. For equipment connected to the scart sockets using a fully-wired 21-pin scart lead Start playback on the connected equipment. For other connected equipment Press / repeatedly until the correct input symbol (see below) appears on the screen. 4: Component input signal through the Y, PB/CB, PR/CR sockets / 4, and audio input signal through the L/G/S/I, R/D/D/D sockets / 4. 5: Digital audio/video signal is input through the HDMI IN 5 socket. Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket. 6/ 6: Video input signal through the video socket 6, and audio input signal through the audio socket L/G/S/I (MONO), R/D/D/D sockets 6. Appears only if the equipment is connected to the S video socket 6 instead of the video socket 6, and S video input signal is input through the S video socket 6. The following options are available in each menu. Only the options that can be operated are displayed. You can select the options listed below on the Picture Adjustment menu. When you set "Mode" to "Vivid" or "Standard", you can adjust only "Mode", "Contrast", "Colour Tone", "Noise Reduction", and "Reset". Press M/m to select one of the following picture modes, then press OK. Custom: Allows you to store your preferred settings. tip You can also change the picture mode by pressing repeatedly. Press </, to set the level, then press OK. Press M/m to select one of the following, then press OK. Cool: Gives the white colours a blue tint. [. . . ] No picture (screen is dark) and no sound No picture or no menu information from equipment connected to the scart connector Distorted picture Check that the optional equipment is on and press / repeatedly until the correct input symbol is displayed on the screen. Check if any connected optional equipment is installed in front of the TV or beside the TV. When installing optional equipment, leave some space between the optional equipment and the TV. When changing programmes or selecting Text, turn off any equipment connected to the scart connector on the rear of the TV. [. . . ]