User manual SONY KDX-46Q005

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Exercise extreme care when lifting or moving this TV. A minimum of two adults should lift or move the TV. Portions of the advanced circuitry of this TV will sometimes operate while the TV is turned off. This allows the TV to download guide information and CableCARDTM updates. [. . . ] For the A/V receiver, press AUDIO to move the navigation to the Audio Section. Highlight the A/V receiver icon and press POWER. If you press POWER on the remote control when the Device Selection menu is not displayed, the TV will turn Off. Video Section The TV icon shows the destination for the device highlighted in the Device Section. Connection Section The Connection Section shows the other devices currently connected to the device highlighted in the Device Section. For example, if the Digital VCR (D-VCR) is currently recording, when you move the highlight to the Ant-1 icon, the D-VCR icon will appear in the Connection Section. This icon will disappear when you move the highlight to another icon. Audio Section When a NetCommand® pre-memorized or learned IR controlled A/V receiver has been connected to the TV and added to NetCommand Setup, an AVR icon will appear in the audio section. Press AUDIO to change navigation to the audio section. Then press ADJUST , , or to select the TV speakers icon or the A/V receiver icon. Press ENTER to change the audio selection. Pressing DEVICE MENU will return to the CableCARD menu screen and pressing HOME will return to TV viewing. If there are technical problems with the CableCARD, an error screen will automatically display with information that may be needed by your Cable provider when you call them for assistance. The screen shown below is an example of the type of screen that may display. Specific screen menus are sent by your cable provider. Most CableCARD screens are status or diagnostic in nature and do not allow you to make changes. These screens are meaningful only to your local cable provider. IMPORTANT Press HOME key to exit Figure 9. Possible Device Menu for CableCARD 56 Chapter 4. IEEE 1394 Devices and NetCommand-Controlled Recordings Using the GUIDE Button to Display ChannelViewTM and Menus The GUIDE Button Please refer to the separate TV Guide On Screen® Interactive Program Guide User's Manual for details about using the GUIDE button with TV Guide On Screen. When you are not using the GUIDE key for the TV Guide screens, pressing GUIDE allows you to see NetCommand® controlled program guides or menus. Devices (139 or IR Controlled) For NetCommand compatible satellite receivers and some cable boxes, GUIDE will display the on-screen programming guide for the receiver or cable box. Press ADJUST , , or and ENTER to navigate the displayed Guide. For NetCommand compatible satellite receivers, you may also be able to use the number or other additional buttons. For NetCommand compatible DVD players, GUIDE will display the DVD disc "top" menu (not the setup menu). [. . . ] This technology creates the image using small dots, or picture elements (pixels). Your LCD Projection TV is manufactured to a high level of performance and quality, in fact, 99. 99% perfect in the number of properly functioning pixels. As in other display technology, sometimes a pixel is continuously active, inactive or the incorrect color. Our standard is clear; MDEA warrants only that the percentage of properly functioning pixels will be not less than 99. 99% of all pixels. [. . . ]