User manual SONY KE-42TS2E

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Note that power consumption will still increase if you increase the Contrast or Brightness. TV Speakers The "TV Speakers" option allows you to control the sound output of the TV's speakers when using your audio system speakers. Then press or to select After selecting the option, press Off and finally press OK to store. Sound of the TV is not output through the TV's speakers. Orbit Range: Select the moving range from Large, Mid (Middle), and Small. Orbit Cycle: Select the moving time from 10sec, 30sec, 1min, and 5min. The "AV3 Output" option allows you to select the source to be output from the Scart connector 3/ S . You can record from this Scart any signal coming from the TV or from external equipment connected to the other Scart connectors. If your VCR supports SmartLink, this procedure is not necessary. If you select Auto, the output signal will always be the same one that is displayed on the screen. If you have connected a decoder to the Scart 3/ S or to a VCR connected to this Scart, please remember to change back the "AV3 Output" to Auto for correct unscrambling. When AV3 Output is set to Auto, the signal input through the AV5 input and the RGB signal are not output from the Scart connector 3/ S . The "AV3 Input, ""AV4 Input, " and "AV5 Input" options allow you to select which jack the TV receives the input signal from; Video or S Video for AV3 Input and AV4 Input, and Component or RGB for AV5 input. Then press After selecting the option, press the desired jack and finally press OK to store. Then press or to select the connected equipment: DTV for a digital tuner with RGB signal, or Others for other RGB equipment. The "Set Up" menu allows you to alter various options of this TV. The "Language/Country" option allows you to select the language that the menus are displayed in. It also allows you to select the country in which you wish to operate the TV set. To do this: and then proceed in the same After selecting the option, press way as in the steps 2 and 3 of the section "Switching On the TV and Automatically Tuning" on page 11. The "Auto Tuning" option allows you to automatically search and store all available TV channels. To do this: After selecting the option, press and then proceed in the same way as in the steps 4 and 5 of the section "Switching On the TV and Automatically Tuning" on page 11. The "Programme Sorting" option allows you to change the order in which the channels (TV Broadcast) appear on the screen. [. . . ] Avoid installing your VCR in front of the TV or at the side of the TV. Poor or no picture (screen is dark), but good · using the menu system , select the "Picture Adjustment" menu sound. And select "Reset" to return to the factory settings (page 14). Using the menu system, select the "Manual Programme Preset" option in the "Set Up" menu and adjust Fine Tuning (AFT) to obtain better picture reception (page 23). [. . . ]