User manual SONY KF-50SX200K

[. . . ] Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and an appropriate plug fitted in accordance with the following instructions: The wires in this mains lead are coloured in accordance with the following code: Blue Neutral Brown Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. [. . . ] Push the joystick $ or 4 to select the relevant programme number, then push z repeatedly to select: a) ATT (RF attenuator) b) VOL (Volume Offset) c) AFT (Automatic Fine Tuning) or d) DECODER Repeat steps 5 and 6 a) to attenuate other channels. B) VOL Push the joystick $ or 4 to adjust the volume level of the channel over a range of -7 to +7, then press the OK button. Repeat steps 5 and 6b) to adjust the volume level of the other channels. c) AFT Push the joystick $ or 4 to fine tune the channel frequency over a range of -15 to +15 , then press the OK button. Repeat steps 5 and 6c) if you wish to fine tune other channels. d) DECODER Push the joystick $ or 4 to select AV1 (for a decoder connected to the Scart :1/ ) or AV2 (for a decoder connected to the Scart :2/q 2 (SMARTLINK)) , then press the OK button. Repeat steps 5 and 6d) to select the AV1 or AV2 output for other programme positions. The picture from the decoder connected to the Scart connector :1/ or :2/q 2 (SMARTLINK) on the back of the set will appear on this programme number. You can programme this set with a personal code, using up to eleven characters (letters and numbers). Then using this fuction it will be possible to identify your set if it was ever stolen. Make sure to write it down in this instruction manual. Push the joystick $ or 4 to select: $ Off (size of picture is not automatically adjusted). Normal (size of picture is automatically adjusted according to the broadcaster information). 4 Full (The set automatically adjusts the picture size to eliminate any dark areas on the TV picture (as shown on the section "Changing the Screen Format"). With the first element of the LABEL column highlighted, push the joystick $ or 4 to select a letter, number, "+" or blank; then push z to confirm this character. Repeat steps 4 to 7 if you wish to select the picture size or label other input sources. Whenever the equipment with the labelled input is selected for use, the name appears for a few seconds on the screen You can manually select which channel you wish to watch, either full-screen or in the PIP. Now 13 programme positions appear on the screen, with the current channel in the centre. Push the joystick $, 4, Z or z to move within the 13 displayed channels. PAP divides the screen into two for watching two channels simultaneously. One of the pictures can be selected to come from a video source. The sound of the left screen comes through the set loudspeakers, the sound of the right screen is selectable via headphones. [. . . ] Also, do not put your hand inside the lamp compartment, as you may be burned. If it is not firmly attached, the picture may become dark. Loosen two screws and pull out the lamp. Loosen two screws with the supplied wrench. [. . . ]