User manual SONY KF-50SX200U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] D) Preset the AV output for the programme positions of channels with scrambled signals (eg from a pay TV decoder). In this way a connected VCR records the unscrambled signal. To select the symbol, then push to enter the Push the joystick or to select Further Programme Preset, then push to to enter. Push the joystick or to select the relevant programme number, then push repeatedly to select: a) ATT (RF attenuator) b) VOL (Volume Offset) c) AFT (Automatic Fine Tuning) or d) DECODER Repeat steps 5 and 6 a) to attenuate other channels. B) VOL Push the joystick or to adjust the volume level of the channel over a range of -7 to +7, then press the button. Repeat steps 5 and 6b) to adjust the volume level of the other channels. c) AFT Push the joystick or to fine tune the channel frequency over a range of -15 to +15 , then press the button. Repeat steps 5 and 6c) if you wish to fine tune other channels. d) DECODER Push the joystick or to select AV1 (for a decoder connected to the Scart :1/ 1) or AV3 (for a decoder connected to the Scart :3/q 3 (SMARTLINK)) , then press the button. Repeat steps 5 and 6d) to select the AV1 or AV3 output for other programme positions. The picture from the decoder connected to the Scart connector :1/ 1 or :3/q 3 (SMARTLINK) on the back of the set will appear on the selected programme number. You can programme this TV set with a personal code, using up to eleven characters (letters and numbers). By using this function it will be possible to identify your TV set if it is ever stolen. Make sure you make a note of it in this instruction manual. Push the joystick to or to select a letter, number, + or a blank; then push to confirm this character. A new menu automatically appears on the screen asking you to be sure that you want to save this ID. A) If you do not wish to store this ID, push the joystick repeat steps 4 to 6 to enter a new ID. B) If you wish to store this ID, press the button. Remember that this code can only be input once. When you enter the Manual Set Up menu, in the "Personal ID" option the code you entered above will be displayed. You will not be able to select and change this option. This function provides an overview of some of the features available on this TV set. [. . . ] Attach the front panel locating the left hand edge of the cover first and then pushing the right hand side back into place. Remove the front panel without moving the TV set. Grasp the right side of the front panel with your fingers and pull it forward. Be careful not to catch your fingernails. [. . . ]