User manual SONY KLV-15SR2

[. . . ] Before operating the TV, please read the "Safety Information" section of this manual. Retain this manual for future reference. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. [. . . ] Use the supplied mains lead (Type C-6 or Type BF, see page 20). Do not connect to the mains before all connections are complete. Connect the supplied mains lead (Type C-6 or Type BF, with safety earth) and the supplied AC power adaptor. Connect the supplied mains lead (Type C-6 or Type BF, with safety earth) and the supplied AC power adaptor. Note that some Scart leads may not fit into the connector on the TV. You can store the cables in the back of the TV. To remove the cable cover, pull the convex part of the cover towards you. It may not be possible to fasten cables that are too thick with the cable cover. If all the cables cannot be stored inside, leave some of them hanging down on both sides of the TV. You can adjust the angle to avoid the reflection of light and get a better view of the TV. When adjusting the angle, hold the stand with your hand so that it does not come loose or fall off. Be careful not to catch your fingers between the TV and the stand. The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen, 2) choose the country/region in which you want to operate the TV, 3) search and store all available channels (TV Broadcast), and 4) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do so by selecting the appropriate option in the "Set Up" menu (see page 40). The first time you switch on the TV, the Language menu appears automatically on the screen (Auto Startup). / / or on the remote control to select the language, then press OK to confirm your selection. Language Select language English Nederlands Français Italiano Deutsch Türkçe Español Português Polski Magyar Press or to select the country/region in which you will operate the TV, then press OK to confirm your selection. If the country/region in which you want to use the TV does not appear in the list, select "­" instead of a country/region. Country Select country ­ United Kingdom Ireland Nederland België/Belgique Luxembourg France Italia Schweiz/Suisse/Svizzera Deutschland Österreich This procedure could take some minutes. Please be patient and do not press any buttons, otherwise the auto tuning will not be completed properly. If no channels are found during the auto tuning process, a new menu appears automatically on the screen asking you to connect the aerial. 7 When the auto turning is finished, the Programme If you want to keep the broadcast channels in the tuned order, go to step 8. [. . . ] Check if any connected optional equipment is installed in front of the TV or beside the TV. When installing optional equipment, leave some space between the optional equipment and the TV. Leave a space of 30 cm between your VCR and the TV to avoid noise. Avoid installing your VCR in front of the TV or beside the TV. [. . . ]