User manual SONY KLV-15SR3E

[. . . ] Before operating the TV, please read the "Safety Information" section of this manual. Retain this manual for future reference. To prevent the risk of electric shock, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed. [. . . ] For channel numbers 10 and above, enter the second digit within two seconds. In Text mode: Enters the three digit page number to select the page. Returns to the previous channel watched (for more than five seconds). Use the tactile dots as references when operating the TV. , to make a note of a telephone number or recipe). To start this function, press and hold this button for three seconds. Lights up in green when the TV is switched on. Lights up in red when the TV is in standby mode. Lights up in red when the sleep timer is set (page 17). Observe the correct polarity when inserting batteries. Do not use different types of batteries together or mix old and new batteries. Do not drop or step on it, or spill liquid of any kind onto it. Do not place the remote in a location near a heat source, or in a place subject to direct sunlight, or in a damp room. Pull the rear cover down slowly, being careful not to catch your hand. tip The rear cover has tabs on the lower right and left side. The cover can be easily removed by pulling out one side while stabilizing the other side with your other hand. Do not carry the TV holding the rear cover. Mains lead AC adaptor (supplied) (supplied) Scart lead (not supplied) Connect your aerial with the coaxial cable. If connecting to an aerial only (A) Connect your aerial to the socket on the rear of the TV, then go to step 3. If connecting to a VCR with an aerial (B) Connect your aerial to the input socket on your VCR. Insert the two tabs of the upper side of the rear cover into the slots of the TV cabinet. 1 Connect the output socket on your VCR to the socket on the rear of the TV with the RF lead. [. . . ] To turn off the sound of the TV speakers, set "TV Speakers" to "Permanent Off" (page 25). 0 cm measured diagonally Display Resolution: 640 dots (horizontal) × 480 lines (vertical) Power Consumption: 50 W Standby Power Consumption: 1 W or less Dimensions (w × h × d): Approx. Design and specifications are subject to change without notice. No picture (screen is dark) and no sound No picture or no menu information from equipment connected to the Scart socket Distorted picture Check that the optional equipment is on and press / repeatedly until the correct input symbol is displayed on the screen. [. . . ]