User manual SONY KLV-26HG2

[. . . ] Buttons shaded white on the remote control show you the buttons you have to press to follow the sequence of the instructions. Mains lead Unplug the mains lead when moving the TV. Do not move the set with the mains lead plugged in. It may damage the mains lead and result in fire or electric shock. [. . . ] Always remember to dispose of used batteries in an environmental friendly way. When you connect the cables, remove the rear cover of the TV set. Be sure to attach the rear cover back on the TV set after you finish connecting the cables. Removing the rear cover Hold the rear cover as illustrated below and pull off one side of the lower part of the cover towards you first. Then, detach the upper part of the cover from the TV set. Repeat this operation on the other side of the cover. Attaching the rear cover Hold the rear cover as illustrated below, fitting the four detents on the rear cover into the corresponding holes on the TV set, then push the rear cover back on to the TV set. It is not necessary to attach the rear cover if you install a wall-mount bracket SU-LW1 (optional accessory). Make sure to connect the aerial before the Scart. The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen 2) choose the country in which you are going to operate the TV, 3) search and store all available channels (TV Broadcast) and 4) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do that by selecting the appropriate option in the (Set Up menu) or by pressing and holding the Auto Start Up button on the top of TV set for more than three seconds, see page 11. In the case of advertisements) or Off (the volume level changes according to the broadcast signal). To do this: Press the MENU button and press v twice to select , then press OK to enter this menu. next , press v or V to select the desired option and press OK. Finally, read below how to operate into each option. POWER SAVING This option allows you to reduce the power consumption of this TV. Then, press v or V to select On (if you wish the TV set to automatically switch the screen format according to the broadcast signal) or Off (if you wish to keep your preference). Even if you have selected "On" or "Off", you can always modify the format of the screen by pressing repeatedly on the remote control to select one of the following formats: SMART: Imitation of wide screen effect for 4:3 broadcast. Conventional 4:3 picture size, full picture information. Compromise between 4:3 and 16:9 picture size. In "SMART", "ZOOM" and "14/9" modes, parts of the top and bottom of the screen are cut off. According to the format of diffussion, black bands can always appear whatever the selected mode. [. . . ] Here are some simple solutions to problems which may affect the picture and sound. ) / No picture or no menu information from · Check that the optional equipment is on and press the button repeatedly on the remote control until the correct input equipment connected to the Scart symbol is displayed on the screen (page 31). Poor picture/Unstable picture Double images or ghosting. Only snow and noise appears on the screen. [. . . ]