User manual SONY KLV-32BX301

[. . . ] When an alternative type of plug is used it should be fitted with a 13 AMP FUSE, otherwise the circuit should be protected by a 13 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] If the screen image becomes dark, flickers, or does not appear, the fluorescent lamp has worn out and should be replaced. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Do not install the TV set in places subject to extreme temperature, for example in direct sunlight, or near a radiator, or heating vent. The TV set is not disconnected from the mains when the TV set is switched off. To disconnect the TV set completely, pull the plug from the mains. To obtain a clear picture, do not expose the screen to direct illumination or direct sunlight. If possible, use spot lighting directed down from the ceiling. If connecting to an aerial only (A) Connect your aerial to the socket on the rear of the TV, then go to step 3. If connecting to a VCR with an aerial (B) Connect your aerial to the input socket on your VCR. Insert the two tabs of the upper side of the rear cover into the slots of the TV cabinet. 1 Connect the output socket on your VCR to the socket on the rear of the TV with the RF lead. 2 Connect the Scart socket on your VCR to the 1/ 1 Scart socket on the rear of the TV with a Scart lead. Do not connect the mains lead to your mains socket until all connections are complete. Push the two tabs of the lower side of the rear cover into the slots of the TV cabinet. When you switch on the TV for the first time, the "Language" menu appears on the screen, then go to "8: Selecting the language and country/region" on page 15. When the TV is in standby mode (the 1/ (standby/sleep timer) indicator on the front of the TV flashes red), press TV +/1 on the remote to switch on the TV. When adjusting the angle, hold the stand with one hand to prevent the stand from slipping or tipping. When you switch on the TV for the first time, the "Language" menu appears on the screen. [. . . ] You can connect a wide range of optional equipment to your TV. To avoid picture noise, do not connect external equipment to the video socket 2 and the S video socket 2 at the same time. For more information on SmartLink, refer to the instruction manual supplied with your VCR or DVD recorder. connect to the audio output sockets to listen to the sound from the TV on Hi-Fi audio equipment. [. . . ]