User manual SONY KLV-S40A10E

[. . . ] Before operating the TV, please read the "Safety Information" section of this manual. Retain this manual for future reference. To prevent the risk of electric shock, do not insert the plug cut off from the mains lead into a socket outlet. This plug cannot be used and should be destroyed. [. . . ] 1 Connect the output socket on your VCR to the socket on the rear of the TV with the RF lead. 2 Connect the scart socket on your VCR to the / 2 scart socket on the rear of the TV with a scart lead. Do not connect the mains lead to your mains socket until all connections are complete. When you switch on the TV for the first time, the language menu appears on the screen, then go to "6: Selecting the language and country/region. When the TV is in standby mode (the 1 (standby) indicator on the front of the TV is red), press TV +/1 on the remote to switch on the TV. Each time you press /, the display changes cyclically as follows: Text t Text over the TV picture (mix mode) t No Text (exit the Text service) To select a page, press the number buttons or PROG +/-. Ensure that the TV is receiving a good signal, or some text errors may occur. When four coloured items appear at the bottom of the Text page, Fastext is available. Fastext allows you to access pages quickly and easily. Whilst you are viewing Teletext, press repeatedly to choose between four different options of brightness. The 4:3 picture is stretched to fill the screen. To make a note of a telephone number or recipe). 4 Press again to return to normal TV mode. Displays cinemascopic (letter box format) broadcasts in the correct proportions. * Parts of the top and bottom of the picture may be cut off. You can adjust the position of the picture when selecting Smart, 14:9, or Zoom. Switch on the connected equipment, then perform one of the following operation. For equipment connected to the scart sockets using a fully-wired 21-pin scart lead Start playback on the connected equipment. You can also press / repeatedly until the correct input symbol (see below) appears on the screen. For other connected equipment Press / repeatedly until the correct input symbol (see below) appears on the screen or press OK to access the Input signal index table. 3: Component input signal through the Y, PB/CB, PR/CR sockets / 3, and audio input signal through the L/G/S/I, R/D/D/D sockets / 3. 4/ 4: Video input signal through the video socket 4, and audio input signal through the audio socket L/G/S/I (MONO), R/D/D/D sockets 4. [. . . ] Remote RM-EA002 (1) Size AA batteries (R6 type) (2) Support belt (1) and screw (2) AC power adapter (1) (KLV-S19A10E only) Mains Lead (1) Design and specifications are subject to change without notice. This TV does not support Sync on Green or Composite Sync. If a signal other than in the above chart is input, it may not be displayed properly or may not be displayed as you set. 1 Measure how long the 1 (standby) indicator flashes and stops flashing. [. . . ]