User manual SONY KLV-V40A10E

[. . . ] Buttons shaded white on the remote control show you the buttons you have to press to follow the sequence of the instructions. This section will help you to: -Insert batteries into the remote control, -Remove the rear cover, -Connect an aerial and VCR, -Automatically tune the TV, Make sure you insert the supplied batteries using the correct polarities. Always remember to dispose of used batteries in an environmental friendly way. When you connect the cables, remove the rear cover of the TV set. [. . . ] When adjust the angle, hold the stand with your hand so that it does not come loose or fall off. Be careful not to catch your fingers between the TV and the stand. The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen 2) choose the country in which you are going to operate the TV, 3) search and store all available channels (TV Broadcast) and 4) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do that by selecting the appropriate option in the (Set Up menu) or by pressing and holding the Auto Start Up button on the top of TV set for more than three seconds, see page 17. The first time that the TV set is connected, it is usually turned on. If the TV is off, press the on/off button to turn on the TV. The first time you switch on the TV, a Language menu appears automatically on the TV screen. Press the V, v, B or b buttons on the remote control to select your language, then press the OK button to confirm your selection. From now on all the menus will appear in your chosen language. Press the v or V button to select the country in which you are using the TV. If the country in which you want to use the TV set does not appear in the list, select "-" instead of a country. Press OK to reset the picture to the factory preset levels. This option is set to Auto to automatically reduce the snowy picture visible in the weak broadcast signal. This option allows you to alter the tint of the picture. Next, press repeatedly v or V to select: Warm (gives the white colours a red tint), Normal (gives the white colours a neutral tint), Cool (gives the white colours a blue tint). The "Sound Adjustment" menu allows you to alter the sound settings. To do this: Press the MENU button and press v to select , then press OK to enter this menu. next , press v or V to select the desired option and press OK. Finally, read below how to operate into each option. This option allows you to customise the sound effect. Next, press repeatedly v or V to select: Natural Enhances clarity, detail and presence of sound by using "BBE High Definition Sound system"*. Dynamic "BBE High Definition Sound system"* intensifies clarity and presence of sound for better intelligibility and musical realism. [. . . ] ) / No picture or no menu information from · Check that the optional equipment is on and press the button repeatedly on the remote control until the correct input equipment connected to the Scart symbol is displayed on the screen (page 38). Poor picture/Unstable picture Double images or ghosting. Only snow and noise appears on the screen. Check if the aerial has reached the end of its serviceable life (3-5 years in normal use, 1-2 years at the seaside) · Keep the TV away from electrical noise sources such as cars, motorcycles, or hair-dryers. [. . . ]