User manual SONY KP-44PS2U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Repeat steps 5 and 6 to skip other unused programme positions. When changing broadcast channels with the PROGR +/- buttons, the skipped programme positions do not appear. You can, however, still select them using the number buttons. With this feature you can: a) Individually attenuate the strength of a channel signal in case of a strong local aerial signal (striped picture). B) Individually adjust the volume level of each broadcast channel. C) Normally the automatic fine tuning (AFT) is operating, however you can manually fine-tune the TV to obtain better reception if the picture is distorted. D) Preset the AV output for the programme positions of broadcast channels with scrambled signals (eg from a pay TV decoder). In this way a connected VCR records the unscrambled signal. Symbol, then push z to enter Push the joystick $ or 4 to select Manual Set Up then push to z to enter. Push the joystick $ or 4 to select Further Programme Preset, then push z to enter. Push the joystick $ or 4 to select the relevant programme number, then push z repeatedly to select: a) ATT (RF attenuator) b) VOL (Volume Offset) c) AFT (Automatic Fine Tuning) or d) DECODER Repeat steps 5 and 6 a) to attenuate other channels. B) VOL Push the joystick $ or 4 to adjust the volume level of the broadcast channel over a range of -7 to +7, then press the OK button. Repeat steps 5 and 6b) to adjust the volume level of the other broadcast channels. c) AFT Push the joystick $ or 4 to fine tune the channel frequency over a range of -15 to +15 , then press the OK button. Repeat steps 5 and 6c) if you wish to fine tune other broadcast channels. d) DECODER Push the joystick $ or 4 to select AV1 (for a decoder connected to the Scart :1/ ) or AV2 (for a decoder connected to the Scart :2/q 2 (SMARTLINK)) , then press the OK button. Repeat steps 5 and 6d) to select the AV1 or AV2 output for other programme positions. The picture from the decoder connected to the Scart connector :1/ or :2/q 2 (SMARTLINK) on the back of the set will appear on this programme number. You can programme this set with a personal code, using up to eleven characters (letters and numbers). Then using this fuction it will be possible to identify your set if it was ever stolen. Make sure to write it down in this instruction manual. Push the joystick $ to select the enter the Set Up menu. [. . . ] In order to get the input signal of a connected equipment onto the TV screen, you need to select the symbol of the connector to which you have connected the device. Press the button repeatedly on your remote control until the correct input symbol appears on the screen. symbol Input signals · Audio/video input signal through the Scart connector A or * RGB through Scart connector A. ⷠAudio/Video input signal through the Scart connector B or * S Video through Scart connector B. [. . . ]