User manual SONY KP-46WT520

[. . . ] Owner's Record The model and serial numbers are located at the rear of the projection TV, below the Sony logo, on the sticker, and also on the TV box (white label). Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. How to Reduce the Risk of "Image Retention" on the Screen Please take the following steps to reduce the risk of causing image retention: · When using video games, computers, and similar products with your projection TV, or viewing a TV station whose logo always stays on the screen, keep the Brightness and Picture functions at low settings. (See page 62 for instructions on adjusting Brightness and Picture settings. ) · View a variety of programming material. [. . . ] Also used to clear Favorite Channels, (see page 58), and Manual Convergence (see page 42). Press repeatedly until the TV displays the time in minutes (15, 30, 45, 60, or 90) that you want the TV to remain on before shutting off automatically. To cancel press until Sleep Off appears. While the Sleep feature is set, press once to display the remaining time. Press to turn on and off the satellite receiver or cable box. Press once to display the current channel number, current time, and program information banner (if set). Press repeatedly to cycle through the video equipment connected to the TV's video inputs. Press to display the Favorite Channels list. Press to have the remote control operate the TV. Functions only while the remote control is in DVD/VCR FUNCTION mode. For details, see "Using the F1 and F2 Buttons" on page 49. Press to switch between the sources connected to the TV's VHF/UHF and AUX inputs. When the remote control is set to operate the satellite receiver, press to display the program guide. When the remote control is set to operate the satellite receiver, press to switch between the satellite receiver's TV and SAT (satellite) inputs. To scan quickly through channels, press and hold down either CH button. Press repeatedly to step through the Audio Effect options. Press repeatedly to cycle through the Multi-channel TV Sound (MTS) options: Stereo, Auto SAP (Second Audio Program), and Mono. For details, see "Using the Audio Menu" on page 64. SETUP qh SLEEP qj SAT/CABLE POWER qk TV POWER ql DISPLAY SETUP w; TV/VIDEO wa MENU ws FAVORITES wd TV FUNCTION wf F1/F2 Remote Control wg ANT GUIDE wh TV/SAT SETUP wj CH +/- SETUP wk wl MTS/SAP SETUP 45 Programming the Remote Control The remote control is preset to operate Sony brand video equipment. If you have video equipment other than Sony brand that you want to control with the TV's remote control, use the following procedure to program the remote control. SETUP The equipment must have infrared (IR) remote capability in order to be used with the remote control. 1 Turn to the list of "Manufacturer's Codes" on page 47, and find the three-digit code number for the manufacturer of your equipment. (If more than one code number is listed, try the number listed first. ) SETUP 2 While holding down DVD/VCR FUNCTION or SAT/CABLE FUNCTION, press Remote Control RESET. (The DVD/VCR FUNCTION and SAT/CABLE FUNCTION buttons will flash. ) 3 Press either DVD/VCR FUNCTION or SAT/CABLE FUNCTION, depending on which button you want to program. 4 Enter the three-digit manufacturer's code number. 5 Press ENT. You must do step 5 within 10 seconds of step 4, or you must redo steps 3 through 5. 6 To check if the code number works, aim the TV's remote control SETUP at the equipment and press the POWER button that corresponds with that equipment. [. . . ] Make sure the Speaker option is set to On in the Audio Menu (see page 65). Increase the volume of the cable box using the cable box's remote control. Then press TV FUNCTION and adjust the TV's volume. The TV's audio might be set to Auto SAP or Mono, when it might be better set to Stereo. [. . . ]