User manual SONY KP-48PS2

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Push the joystick to $ to select the enter the Set Up menu. Push the joystick to $ or 4 to select Manual Set Up then push to z to enter. Push the joystick to $ or 4 to select Further Programme Preset, then push to z. Push the joystick to $ or 4 to select the relevant programme number, then push to z repeatedly to select: a) ATT (RF attenuator) b) VOL (Volume Offset) c) AFT (Automatic Fine Tuning) or d) DECODER Repeat steps 5 and 6 a) to attenuate other channels. B) VOL Push the joystick to $ or 4 to adjust the volume level of the channel over a range of -7 to +7, then press the OK button. Repeat steps 5 and 6b) to adjust the volume level of the other channels. c) AFT Push the joystick to $ or 4 to fine tune the channel frequency over a range of -15 to +15 , then press the OK button. Repeat steps 5 and 6c) if you wish to fine tune other channels. d) DECODER Push the joystick to $ or 4 to select AV1 (for a decoder connected to the Scart :1/ ) or AV2 (for a decoder connected to the Scart :2/q 2 (SMARTLINK)) , then press the OK button. Repeat steps 5 and 6d) to select the AV1 or AV2 output for other programme positions. The picture from the decoder connected to the Scart connector :1/ or :2/q 2 (SMARTLINK) on the back of the projection TV will appear on this programme number. Your projection TV is now ready for use. You can programme this projection TV with a personal code, using up to eleven characters (letters and numbers). Then using this fuction it will be possible to identify your projection TV if it was ever stolen. Make sure to write it down in this instruction manual. Push the joystick to $ to select the enter the Set Up menu. Push the joystick to $ or 4 to select Manual Set Up, then push to z. Push to $ or 4 to select Personal ID, then push to z. Push the joystick to $ or 4 to select a letter, number, + or a blank; then push to z to confirm this character. A new menu appears automatically on the screen asking you to be sure that you want to save this ID. A) If you do not wish to store this ID, push the joystick to Z and repeat steps 4 to 6 to enter a new ID. B) If you wish to store this ID, press the OK button. [. . . ] For the best picture quality, try to position the projection TV so that you can view the screen from within the areas shown below. Design and specifications are subject to change without notice. Here are some simple solutions to the problems which may affect the picture and sound. Turn the projection TV off for 3 or 4 seconds and then turn it on again using the button on the front of the projection TV. [. . . ]