User manual SONY KP-51DS1U

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Push the joystick to $ or 4 to select the programme number with the channel you wish to block, then press the OK button. The symbol appears before the programme position to indicate this programme is now blocked. Repeat step 4 if you wish to block other channels. When you select a blocked programme the screen appears in black, with symbol. You can programme this projection TV to skip any unwanted programme numbers when they are selected with the PROGR +/buttons. To cancel this function afterwards, proceed in the same way as described below by selecting the appropriate TV system (I or DIG) instead of "- - -" in step 5. Push the joystick to $ to select the enter to the PRESET menu. Push the joystick to $ or 4 to select Manual Programme Preset, then push to z. Push the joystick to $ or 4 to select the programme position you want to skip, then push to z to enter to the SYS column. Push the joystick to $ to select "- - -", then press the OK button to store. Repeat steps 4 and 5 to skip other unused programme positions. When changing channels (TV Broadcasts) with the PROGR +/- buttons, the skipped programme positions do not appear. You can, however, still select them using the number buttons. Names for analogue channels (TV Broadcasts) are usually taken automatically from Teletext if available. You can however name a channel or an input video source using up to five characters (letters or numbers). Using this function, you can easily identify which channel (TV Broadcasts) or video source you are watching. Push the joystick to $ to select the enter to the PRESET menu. Push the joystick to $ or 4 to select Manual Programme Preset, then push to z. Push the joystick to $ or 4 to select the programme number with the analogue channel you wish to name. Push the joystick to z repeatedly until the first element of the LABEL column is highlighted. Push the joystick to $ or 4 to select a letter or number (select "-" for a blank), then push to z to confirm this character. Repeat steps 4 to 7 if you wish to label other channels. [. . . ] In order to get the input signal of a connected equipment onto the TV screen, you need to select the symbol of the connector to which you have connected the device. Press the button repeatedly on your remote control until the correct input symbol appears on the screen. To return to the normal TV picture, press the button on the remote control. Tuning information such as the channel overview are downloaded from the projection TV set to the VCR. [. . . ]