User manual SONY KP-51PS2

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] In this way a connected VCR records the unscrambled signal. Symbol, then push z to enter Push the joystick $ or 4 to select Manual Set Up then push to z to enter. Push the joystick $ or 4 to select Further Programme Preset, then push z to enter. Push the joystick $ or 4 to select the relevant programme number, then push z repeatedly to select: a) ATT (RF attenuator) b) VOL (Volume Offset) c) AFT (Automatic Fine Tuning) or d) DECODER Repeat steps 5 and 6 a) to attenuate other channels. B) VOL Push the joystick $ or 4 to adjust the volume level of the broadcast channel over a range of -7 to +7, then press the OK button. Repeat steps 5 and 6b) to adjust the volume level of the other broadcast channels. c) AFT Push the joystick $ or 4 to fine tune the channel frequency over a range of -15 to +15 , then press the OK button. Repeat steps 5 and 6c) if you wish to fine tune other broadcast channels. d) DECODER Push the joystick $ or 4 to select AV1 (for a decoder connected to the Scart :1/ ) or AV2 (for a decoder connected to the Scart :2/q 2 (SMARTLINK)) , then press the OK button. Repeat steps 5 and 6d) to select the AV1 or AV2 output for other programme positions. The picture from the decoder connected to the Scart connector :1/ or :2/q 2 (SMARTLINK) on the back of the set will appear on this programme number. You can programme this set with a personal code, using up to eleven characters (letters and numbers). Then using this fuction it will be possible to identify your set if it was ever stolen. Make sure to write it down in this instruction manual. Push the joystick $ to select the enter the Set Up menu. Push the joystick $ or 4 to select Manual Set Up, then push z to enter. Push $ or 4 to select Personal ID, then push z to enter. Push the joystick $ or 4 to select a letter, number, + or a blank; then push z to confirm this character. A new menu appears automatically on the screen asking you to be sure that you want to save this ID. A) If you do not wish to store this ID, push the joystick Z and repeat steps 4 to 6 to enter a new ID. B) If you wish to store this ID, press the OK button. Remember that this code can only be input once. [. . . ] 84 kg Accessories supplied 1 Remote Control (RM-903) 2 Batteries (IEC designated) Other features DRC 100 Hz picture Digital Comb filter (High resolution) TELETEXT, Fastext, TOPtext (2000 page TEXT memory) NexTView NICAM Sleep Timer Smartlink Digital Noise detection Graphic Equaliser Personal ID Auto Format picture Design and specifications are subject to change without notice. Here are some simple solutions to the problems which may affect the picture and sound. Turn the set off for 3 or 4 seconds and then turn it on again using the button on the front of the set. Poor or no picture (screen is dark), but good sound. [. . . ]