User manual SONY KP-53V90

[. . . ] â· After transporting the projection TV directly from a cold to a warm location, or if the room temperature has changed suddenly, pictures may be blurred or show poor colour over portions of the picture. This is because moisture has condensed on the mirrors or lenses inside the projection TV. To obtain a clear picture, do not expose the screen to direct illumination or direct sunlight. If possible, use spot lighting directed down from the ceiling. [. . . ] When you select a named channel, the name appears for a few seconds on the screen. You can programme this projection TV to skip any unwanted programme numbers when they are selected with the PROGR +/buttons. To cancel this function afterwards, proceed in the same way as described below by selecting Off instead of On in step 6. Push the joystick to $ to select the enter the Set Up menu. Push the joystick to $ or 4 to select Manual Set Up, then push to z. Push the joystick to $ or 4 to select Manual Programme Preset, then push to z. Push the joystick to $ or 4 to select the programme position you want to skip, then push to z to enter the SKIP column. Push the joystick to $ to select On, then press the OK button to store. Repeat steps 5 and 6 to skip other unused programme positions. When changing channels (TV Broadcasts) with the PROGR +/- buttons, the skipped programme positions do not appear. You can, however, still select them using the number buttons. Repeat steps 4 to 6 if you wish to label other input sources. Whenever the equipment with the labeled input is selected for use, the name appears for a few seconds on the screen. You can manually select which channel you wish to watch, either full-screen or in the PIP. Now 13 programme positions appear on the screen, with the current channel in the centre. Push the joystick to $, 4, Z or z to move within the 13 displayed channels. PAP divides the screen into two for watching two channels simultaneously. One of the pictures can be selected to come from a video source. The sound of the left screen comes through projection TV loudspeakers, the sound of the right screen is selectable via headphones. With PAP switched on, press the number buttons (to select a TV channel) or press . When the symbol appears at the bottom of the right screen, press the number buttons (to select a TV channel) or press . With PAP switched on, press the swap the two screens. [. . . ] â· Direct projection TV recording: While watching TV you need to press just one button on the VCR to record this programme. If you have connected a decoder to a VCR which supports Smartlink feature, select the menu Further Programme Preset in the (Manual Set Up) menu and select DECODER AV2 to each coded channel. For more details, please refer to the section "Using the Further Programme Preset function" of this instruction manual. For more information on Smartlink, please refer to the Instruction Manual of your VCR. [. . . ]