User manual SONY KV-13TR10

[. . . ] Do not install the unit where it may be exposed to mechanical vibrations. Television programmes, films, video tapes and other materials may be copyrighted. This video TV is designed to receive TV programmes based on PAL (I) colour system and to record and play on PAL colour system. The video TV can also play tapes on NTSC colour system. [. . . ] Plug the headphones (not supplied) into the 2 (headphones) jack which is located behind the cover on the front of the video TV. The sound from the speaker is turned off. The Teletext service allows you to receive various information, such as weather forecasts or news, at any time. 1 Select the TV channel which carries the Teletext service you want to watch. 3 Press the number buttons to enter the three digits of the Teletext number you want. The numbers are displayed on the screen and the requested page appears in a few seconds. If you have made a mistake, type in any three digits, then re-enter the correct page number. This feature allows you to access a Teletext page by pressing only one button. When a Fasttext page is broadcast, a colour-coded menu appears at the bottom of the screen. The colours of the menu correspond to the red, green, yellow and blue buttons on the remote control. The page is displayed after a few seconds. The tape counter helps you to locate a certain scene after playback. The video TV keeps counting the length of the tape being played. Note, however, that the tape counter does not count the portions without video signals recorded. You can play the recorded portion of a tape repeatedly. 2 Using the + or ­ buttons, move the cursor (z) to "VCR MODE, " then When the tape reaches its end, it will automatically rewind and begin playing again. You can use the REPLAY key on your remote control to automatically replay scenes. The tape will rewind for ten seconds of viewing time and then begin playing automatically. If you wish to replay more than ten seconds, press REPLAY repeatedly. Each time you press the button, it will add ten seconds onto the playing time, up to a total of 40 seconds. Normally, you will want to leave the colour system on AUTO. However, if you notice streaks appearing on the screen during playback, you may want to set the colour system to the system that the tape was recorded in. [. . . ] Problems Possible causes and remedies No picture (screen is · The connecting cord between the video TV and the input source is sound from video disconnected. The power has been interrupted, the U (MAIN POWER) switch is turned off or the mains lead is disconnected for more than a week. / Switch off, disconnect the mains lead, and leave the set for about tape does not run. Poor playback picture · / Clean the heads using the Sony V-25CL video head cleaning tape (page 46). [. . . ]