User manual SONY KV-14LM1B

[. . . ] If this happens, the tape may stick to the head drum and it may be damaged or the unit may not operate correctly. To avoid possible damage caused by moisture condensation, be sure not to leave a cassette inside the compartment when the unit is not in use. When bringing the unit from a cold place to a warm place, turn on the unit's power and wait for more than 2 hours before operating it. To prevent fire or electric shock, please follow the safety procedures below. [. . . ] The chart below shows the recording/playback time available in each mode. In the SP mode, the tape runs twice as fast as the LP mode, and three times as fast as the EP mode. â· When a PAL format cassette is used with the NTSC system for recording, the actual recording time is shorter than the standard recording time stipulated on the cassette. The Quick-Timer recording function allows you to preset your video TV to record one program within a 24-hour period. Make sure that the loaded cassette has its safety tab intact. â· Make sure that the video TV does not enter the timer recording standby mode (the TIMER REC indicator on the video TV should not be lit. When the TV is in standby mode (the 1 indicator on the video TV is lit in red), the power is turned on automatically. EP cannot be selected when making timer recordings. Turn QUICK TIMER to set the hour of the start time, then press QUICK TIMER. The hour is set and the minute of the start time turns red. Turn QUICK TIMER to set the minute of the start time, then press QUICK TIMER. Remember to press ON/OFF again to make the TIMER REC indicator light up after setting the recording time. To add, change or clear the settings, follow steps 2 through 4. Press < or , to move the cursor to ADD, CHANGE or CLEAR, then press ENTER. To add new settings Follow steps 2 through 4 of "Setting the timer" on page 26. To change the settings Press M or m to move the cursor to the setting you want to change, then press ENTER. Follow steps 2 through 4 of "Setting the timer" on page 26. To clear the settings Press M or m to move the cursor to the setting you want to clear, then press ENTER. Press < or , to move the cursor to OK, then press ENTER. If there are other timer settings on the list, the video TV enters the timer recording standby mode and the TIMER REC indicator lights up. The second program starts recording only after the first program has finished. Some programs are broadcast at different volume levels. [. . . ] if the problem persists , contact your Sony dealer. Symptom TV section No picture/No sound The power cord or antenna Check the AC power cord and the antenna connections. Good picture/No sound The volume level is too low. Broadcast signals are reflected by nearby mountains or buildings. [. . . ]