User manual SONY KV-14V4B

[. . . ] ⷠTo avoid battery leakage and damage to the remote, remove the batteries from the remote if you are not going to use it for several days. If any liquid leaks from the batteries and touches your skin, immediately wash it away with water. For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms. For children's safety, do not leave children alone with the TV. [. . . ] If you find any problem while viewing your TV, you can either use the "Factory Settings" function or check the Troubleshooting guide below. Your TV will go blank for a few seconds, then the "Initial Setup" menu will appear. Your TV will be set to factory settings, but certain problems may be solved. symptom Snowy picture, noisy sound (main power) on the TV to turn off the TV for about five seconds, then turn it on again (see H). Distorted picture, noisy sound Good picture, noisy sound No picture, no sound Good picture, no sound Dotted lines or stripes Double images or "ghosts" Do not use a hair dryer or other equipment near the TV. Display the "Picture" menu and select "Custom" from "Picture Mode", then adjust the "Color" level from "Picture Adjustment" (see K). Keep external speakers or other electrical equipment away from the TV. Keep external speakers or other equipment away from the TV. Do not move the TV while the TV is turned on. (main power) on the TV to turn off the TV for about 15 minutes, then turn it on again to demagnetize the TV. Or Stereo broadcast sound switches on and off or is distorted. Make sure the "Picture" icon ( ) is selected, then press . Press V or v to select "On", then press To cancel, select "Off", then press . "Intelligent Picture Signal Level" indicator will be displayed, followed by picture improvement when you change the program number or the input mode. Red amber green (weak) (average) (good) Press V or v to select "On", then press . * You can adjust the setting to your personal preference in the "Picture Adjustment", "Color Temperature" and "VM" options only when the "Custom" mode is selected. Press V or v to select either "Picture" (contrast), "Brightness", "Color", "Hue" (color tones) or "Sharpness", then press . Selecting "Reset" will set your TV to the factory settings. Press V, v, B or b to adjust the setting of your selected item, then press Repeat the above steps to adjust other items. The adjusted settings will be received when you select "Custom". Reducing "Sharpness" can also reduce picture noise. Choose either "TruSurround"(surround sound that spreads out to the rear of a room), "WOW"** (full, deep bass sound), "Simulated" (stereo-like monaural sound) or "Off". [. . . ] (2) Press V or v until the desired channel's broadcast appears on the TV screen, then press . (2) Press V or v until the sound becomes normal, then press If you are not satisfied with the picture and sound quality, you may be able to improve them by using the "Fine" tuning feature. (3) Press V, v, B or b until the picture and sound quality are optimal, then press The + or ­ icon on the menu flashes while tuning. If the TV signal is too strong (picture distorted; picture with lines; signal interference) or weak (snowy picture), you may be able to improve the picture quality by setting the "Signal Booster" feature. [. . . ]